NJ B.S. Thread

blocks, spacers, and ditch lights are the best option around these parts. Not sure on the alignment specs but I'm guessing someone in the 3rd gen section will know that.

 

howd you get your truck on a post card?

 

What part of Jersey is this? The pine barrens right?

 

I got a good amount of overland street cred

Yea I went in by Pic a lilli

 

So you think I would be with 40s and no cutting?

 

only if you make right turns for the rest of the trucks life.

 

You’re looking to get about 69 degrees of positive caster and 4.20 degrees of negative camber and should nail it only if you get a 200mm wheel spacer. Glad the third gen owner is here to help you guys would be nowhere without my instagram knowledge

 

You son of a bitch.

 

Been a hot minute since that guy made an appearance.

 

Anyone have any tips for removing stucco on interior walls? My entire garage is stucco including the ceiling and I want to repaint and reorganize everything in the fall. From what ive seen you basically have to wet it a bit then scrape it off which would take days

 

Is it stucco or popcorn paint?

 

I believe its stucco, it looks kinda like this:

 

That looks like a waterproofing paint applied with a wire roller. Makes that kind of finish. It would be more troublr than its worth to try to get rid of it.

 

Tear out old Sheetrock and start new.

 

How you been Mojo?

So much this.

 

that to me seems like one of those projects that you’ll spend 10x as much energy and it’ll look 1/2 as good. Just starting fresh would be the route I’d take, plus you can run additional outlets, air lines, etc. behind the walls while it’s out.