Sold

Sold

 

Any chance, since they are weld-on, that they would fit the 2nd gen regular cab?

 

I’m not sure actually. I have the legs placed specifically to avoid the body mounts on a first gen. I’m guessing that the body mounts are in a different location for a second gen RC. Worst case it would mean cutting off / moving a leg. The second obstacle it overall length. If you measure from fender flare to fender flare (center to center) and the length is about the same then you should be gold. I can’t guarantee fitment though.

I do know from experience that fitment of DCSB sliders are VERY similar between 1st, 2nd and 3rd gens with a slight movement of two mounting legs and the overall length is spot on between the three.

 

Surprised they're still here.

To anyone looking at these, the attention to detail for anything made from the OP is above and beyond what I'd expect from anyone; from the angle of the legs to the offset gusseting on the mounting points, even the paint job on them!

Bump for an awesome fabricator.

 

Thanks brother. It’s a shame that the original customer didn’t follow through with these since regular cabs are harder to find than DCSBs. Something tells me I’ll have these for a while before someone picks them up.

 

Their loss.

I'll have to get some sliders from you in the near future for another vehicle; if you find a buyer up here I'd be willing to drive them up north for ya.

 

I’m heading to AZ in about two weeks and I can transport them that way too but won’t be bringing my welder to install.

 

I'm tempted, any idea what shipping would run to 64015?

Not that I run into many slider situations here, our malls have pretty low parking stops.

 

No idea on shipping. They’d most likely have to ship freight so that can get pricey without a business account. But since I wouldn’t be installing, I’d offset the price accordingly. I can try and get a quote this coming week if you’re on the fence.

 

Shipping is going to be hell, and on the fence is accurate. If I knew it was something I wanted, I'd be all over it.


On the other hand, I vaguely remember @Tacoma1997White4x4 was saying something about sliders a while back.

 

For reference, I looked into shipping a set of sliders from AL to MD...cheapest was almost $200 through Greyhound freight (with online discount). GWLS.

 

I’m good 4xinnovation sliders will be imstalled on my truck this week

 

Are these still available?

 

Yes they are.

 

Wish they were for an extended cab....

 

I can make those too.

 

Extended cab?

 

These are for a regular cab but I can make some for an extended cab as well.

 

How much to ship to hawaii?

 

Curious, what would that cost? You can send a PM, if you prefer.