3Pooches version 3.5

What was the issue?

 

So, after buying eBay o2s and urd extension harnesses, then a set of Bosch with longer harnesses to try to figure out my a/f issue, it turns out it was my eBay cold air intake. I put the stock air box on and it runs!

 

It was a combination of a bad master cylinder, sticking brake caliper hardware and worn pads. I'm almost positive I blew out the rear seal on the MC when I slammed on the brakes after seeing that tire flying at me, considering that's when all the issues began.

 

As if there isn’t enough stuff to work on. I have a set of urd o2 extension harnesses coming this week that I don’t need if you are interested.

 

Ok fellas, I think we have 10 or 11 trucks coming on the 10th, I think we can house more!

We opened up a couple new camping spots

Fast track has been smoothed

crossover points between trails and pasture have been added

and new trails!

so come join in on the 10th!

 

Holy shit you've been busy!

 

We are ready to have some fun buddy!

 

Yessir!

 

Fuck. Makes me wish i had a truck.

 

I set the radio presets in the element for you

 

Metal arrived for fabbing and it looks like everyone From dc and Maryland finally went home so we did some fishing yesterday.

 

Today we are putting 4.88 gears and Arb air lockers into the little taco.

and possibly installing a high clearance rear bumper if time allows.

 

What are you fabbing up?

 

Im going to build @Darkgoatracer a new truck

honestly I don’t know exactly yet. Nick and I need bumpers and I’m debating making a tube bed but we will see. I’ve been playing on bend tech and have a couple ideas. I got some DOM and some aluminum tubing and I was thinking about making a hybrid bed

 

Me dreaming about how I have a truck and Nick doesn’t.

 

Made a trailer hitch

 

You found your nuts!

 

They where in a sac I dropped them into years ago.

 

High clearance installed on the little taco. Looks way better

 

I’m planning on removing the panhard bar and single upper link on my rear suspension set up and replace them with a wish bone upper link. This should keep the rear axle centered through out its travel instead of moving in an arc. Here is the crossmember I’m making to attach the cab side on the wish bone to. It will go up over the drive shaft and parallel the factory crossmember