What Have You Done To Your 3rd Gen Today?

Awesome, there are a few spots behind the tail light. I guess our installs are quite similar. I run the line through a hole in a stainless steel bracket i had already then placed a stainless lock nut on a factory screw.

 

I had used stickies like those 3M, they tent to let loose after a while...i went solid install on mine.

 

got new wheels

 

Congratulations!

 

Got one of this, good to have on board!

 

Nice! Where did you get them? I’m interested.

 

he was totally looking for a way to pin it on you.

 

I have the same bed rails. Never thought of using them that way. Thanks for sharing

 

New wheels are one of the better joys of owning a Taco.

 

Handles on, lights on.

 

Installed a Leer 100XR & Leer (Tepui) RTT last month. Made my own shell mounts to keep the rails open for other uses. Made my own tent mount. Installed an Air-Lift overload today to help with the added weight.

 

Agree ! I have not done nameplates and such but on some other projects, I have had some great success with this heavy duty tape from Gorilla. This stuff is insane:

$8 Gorilla Heavy Duty Double Sided Mounting Tape, Black Tape, 1" x 120" (Pack of 1) - Weatherproof for Indoor or Outdoor

https://www.amazon.com/Gorilla-Heav...a-870503340439&psc=1&ref=&adgrpid=90728780141

 

Installed an ARB Twin air compressor today.

Now I can fill up the beach balls and inner tubes.

 

Finally had a chance to look over the truck after driving with fire everywhere and only a little blistering of the expel in a couple of places. Tomorrow an all day cleaning.

 

what is the process to go about installing one of these? More interested in this than say, a VIAIR portable compressor.

 

Installed a procomp 2.25 spacer lift up front and 1" block in rear and now throwing code for stabilatrac and tss. I expected the tss, will try another washer or 3 to adjust the angle, didn't expect the stabilitrac issue, are the 2 related? What did i do wrong?
2020 off road, 2wd. Just disconnected negative battery and waited to see if its resets itself ugh!
Ugh

 

Off Road 2WD? That makes as much sense as a screen door on a submarine.

 

It's not too hard. As the picture shows, I mounted it on the passenger side, near the firewall. There is plenty of room there for it.

I used a tray from Slee Off Road. That mounts up with a few bolts and existing bolt holes. The compressor mounts right on top of that tray. Then it's just wiring. The wiring harnesses come with the compressor. I put the switch in that cubby, on the left side of the steering wheel. The hardest part was finding an appropriate acc wire and dash light wire to tap into for the switch.

 

Don't need 4x4 , the locker is all I need.

 

Finally! 7.5 wks later the leer is on.