What Have You Done To Your 3rd Gen Today?

Installed sumo springs today. With a cap on and empty bed they just start touching the frame. Should be a big help when I load up for camping.

 

Do you have a link or part # for the tray that mounts the ARB compressor?

 

Good choice on lights but I only see them mounted. Lets see light on.

 

Yep! https://sleeoffroad.com/product/sok0038/

 

I did not get around to washing the truck, but I did get a better picture of the bumper. Like my front bumper, it's a 4Xinnovations unit. It was not too bad to install, but I did have a couple people to help with lifting it into place. If you're installing it on your own, it would be very helpful to use a transmission jack or something like that. You do also have to remove the plate lights and trailer plug-in, but it's not hard and the bumper came with mounting brackets for them so you can just reuse everything as-is, no splicing or wiring required. Make sure you have some big zip ties to re-secure the plate light harness, though.

It's a nice bumper overall, I like it!

 

Thought I’d share this. So cool

https://youtu.be/OkFUoKVVygw

 

Added TRD Pro Tail lights for my efforts to remove chrome. I went with actual Toyota brand versus the imitation as there are some differences. Figured for about a few dollars more why not go with Toyota brand. Part numbers are 81560-04230 (Left) and 81550-04230 (Right).

 

@oostroma

SLEE is stainless. In retrospect I may have preferred it. Most people seem to consider it the best in class.

I went with a GTFO bracket which is black mainly for the extra round holes as I intend to use it for power rather that for my compressor.

 

Got 1 crossmember installed on my Fabtech bracket lift Total Chaos Long travel project.

 

I'm thinking of doing this soon as well. Did those part number include the entire assembly? Anything you had to move over from the old lights to the new ones?

 

T-nuts replaced for the Yakima rack install - allows me to slide the bars forward 1.5" and back 1.5" and also allows me to put the tie downs back on.


Prinsu rack installed. Adjusted Yakima rack bar's to match the Prinsu rack height.


Yakima Side Bars installed with extender piece back in (needed the T-Nuts to push the bars out farther apart).

 

Thx for the link. That price is a bit better.

 

Welcome to TW Rick!

 

It seems like the output on your compressor still has the red plastic plug in and you are missing the ARB manifold and the air chuck from pump up kit.

 

They do look nice.

 

Those look awesome! Are you at stock height? Any rubbing?

 

I think you answered your own question here.

 

They were about 135 a piece and free shipping because I picked them up at my local dealership. The imitations run about the same price but don’t have have that black strip. A small difference that mattered to me.

 

That's not too bad as far as price. At present I have the stock rear tail-lights on mine. Thinking of going with the TacomaBeast LED 2020 taillights in Black Smoked. But I do like the TRD Pro tail lights though.