1st Gen Lunchtable Thread - General Discussion

What is the deal with this rear o2 and it going into the cab, should I just cut it ? (Replacing)

 

Cut what exactly? The rear o2 wiring connects to a plug in the cab, I would definitely not cut the wiring

 

If I understand correctly via pictures the new one is male and has enough length to go up through that cab hole and connect with the male ? As in the cut the wire at the sensor for ease since it’s being replaced

 

If I remember right I had to take the side floor trim off (couple screws) and pull back the carpet to reveal the connector

 

My logic of cutting was to drop the whole exhaust so I can pull the old o2 out and then salvage the test pipe section

 

Ehhh I stopped being lazy and got the connector out

 

I put triple sec in the vodka and now it's drinkable

 

A normal person just doesn't drink something if it sucks.

 

Have you ever considered me normal

 

One last hanger I could get off, then it got dark. Then I lost my screwdriver lol. Well I’m glad I got all the rusty bolts and nuts that were worrisome.

 

Need to go pickup a shielding gas bottle. Then wait for my hood and other odds and ends to get here. Not sure if I'll cause issues with my roommate rolling the flatbed into the garage. Might just be stuck welding outside. Technically I have a Argon/CO2 75/25 mix cylinder already filled but I just paid to have it filled and don't own the bottle. Depressing that there's a superior Millermatic, bottle, wire, extension cord, and everything else just sitting unused across the garage.

 

Pretty sure he wants you to stop giving him beer...

 

He'd probably be more fun if I did give him beer

 

Ooo
https://www.instagram.com/p/CFvHh6hAmzs/?igshid=17edngkuk62a4

 

This boy is so old. He's a real sweetheart though

 

I'm fine with looking at those low toyota pages but when I see a 1st gen 4Runner slammed it gets me. I just don't agree with it lol.