Rear sagging

Hey guys, bought a 2016 TRD OR, it already had 2 inch blocks on front and rear but still running 265 70 16s so I promptly went with 255 85 16s and I love the look. I added the Decked.com drawer system a small bed rack and basket for a full size spare to sit in. Needless to say I have more sag in the rear than I can take. Today I added the Sumo Springs and gained about ¼ inch. What can I do relatively cheap to get one or two inches, dont mind the rake if it ends up higher than the front.

 

Best I got is, get rid of the stock springs.
They are no good, even worse when any weight is added.
The bad part is, you want cheap, and aftermarket packs “aren’t cheap”.

 

Single leaf AAL.

 

Add-A-Leaf is a good option if you can install it yourself. In my opinion, there is no inexpensive way to correct the issue without making the situation a whole lot worse later on.

 

Thought you were talking about your wife. Carry on.

 

If I do the OME 3 inch leaf kit do I need to remove the 2 inch block?

 

I would. You don’t want to “stack” lifts. While you can run a small block (1/2 in to 1 in) with a single add a leaf, I would avoid the 3 leaf AAL and 2 in block combo and just stick with the 3 leaf AAL or new pack whichever you go with. You would have all sorts of issues running a 3 leaf AAL and a 2 in block. Best of luck.

 

OME isn’t an AAL, it’s a whole pack.
Replace the whole pack or add a single AAL to what you have now.

Wouldn’t recommend a 3 leaf AAL for your use, not meant for constant load. Also, keep your overload leaf installed.

 

Agreed. Either way, 3 leaf or new OME pack equals no go with a 2 inch block on top of that.

 

Thanks for the good advice guys.