Front license plate solutions?

I just picked up a 3rd gen brand new and don’t want to drill holes into my front bumper. I do reside in a 2 plate state so therefore i’m out of luck. I wanted to hear if anyone has solutions they did that didn’t require drilling or cutting of some sort??

thank you!

 

Go without one? I've never had a front plate on my cars; no issues.

 

I just used the factory license plate mounting bracket. It requires 2 screw holes in the front 'bumper', but who cares, you have a license plate there anyways.
If you move somewhere where it isn't required later, you could use grommets to plug the holes.

 

@ACEkraut should have the no drill brackets you are looking for to mount your front plate.

 

jammed between windshield and dashboard?

 

My no bracket, IDGAF solution. My bumper was already drilled with the fugly mount installed. So, I put two more wider holes in the plate to match.

 

Mine came with a bracket preinstalled. I didn't realize that's not the way they come from the factory. I have the say the bracket is super flimsy and I've already had to tighten the two screws once.

 

Careful with overtightening, don't want to cross-thread the plastic or it will never be tight again.

 

I'm aware, but they were not even finger tight and at risk of falling out.

 

As opposed to the underbite chin being loose in the clips to start with?

 

Elaborate please..

 

It’s considered unlawful in my state to do that.

 

Some folks are lucky and some aren’t lol

 

Zip-tie to grille.

 

Uhg, 5 years of this truck later and they still haven't addressed it.

 

It would have been cool to do a small styling change to clean up front with the 2020 refresh. Oh well though . . .

 

Super flimsy and super ugly. It sticks out much too far for my taste.

 

Why spend more when less spend still get more?

 

Very true. They quickly sell every one that they make.

The fact that folks worried about sales numbers with the Ranger and Gladiator coming online. Haha!