1st Gen Lunchtable Thread - General Discussion

Self-clearancing. Tuck them up tight, my Tacoma was the same. It just dings the pinch weld a little, not a big deal. @BartMaster1234

 

Yeah it's not bad at all. I knew a guy with bolt on sliders on his 4th gen 4runner that would flex up so bad when hi lifted that he couldn't open his door when he set it back down lol. Had to jump up and down on them

 

Oh so the entire main tube is under the pinch weld. I think I had it further out where only the arms would be under the pinch weld. Do you have pics from afar? Curious how far you have it out.

 

Yeah, not doing bolt on sliders, that's for sure. I'm planning on getting the 4xInnovations sliders at some point soon-ish.

 

Yeah give me a min I have to grab the baby and bring her out with me lol

 

These were the ones on my Tacoma. The square main tube was just outside of the pinch weld. Like an RCH.

 

Hope these help








I dunno if the brand of sliders matters but mine are custom built

 

As were mine. Your square main bar is inside the pinch weld where mine was outside. Works either way tho.

 

Nice!

I see you're asking about clearance etc

Maybe @GHOST SHIP can chime in; he did the sliders on my Tacoma and they were perfect.

 

I guess it would depend on how long the arms are that weld to the frame in that case? I sometimes wish mine stuck out just a little bit more than they do

 

https://www.instagram.com/p/CGD4iV-n2r_/?igshid=vmh5tfw0m5m8

 

@xtremewlr https://www.instagram.com/p/CGD6o0NHUsq/?igshid=12j9ihtjhvgb0

 

Very mall crawly. I do like the front bumper tho.

 

All that armor and then nerf bars lol. I sometimes wonder why but I guess mall crawlers gonna mall crawl

 

And they don't wear makeup. Also, the wedding ring is missing.

 

@xtremewlr

 

Where the hell has @FLBAdrian been

 

He lurkin