upTOP Overland Racks and Accessories - NOW WITH FREE SHIPPING (CONUS ONLY)

I purchased late last night.. I'll probably be getting a truss later down the road..thanks for the response!

 

Just an FYI I received my Bravo Rack a couple days ago after 6 weeks only to find out that they have no light bars from Extreme LED in stock and also Extreme LED is saying they MIGHT start shipping first week of November....What a bummer...

 

Wow. Seems like they have been out of stock for a while, then. I was looking at them three months ago or so, maybe more.

 

Nice mate, that's clean. Great idea.

 

such an awesome idea.

 

Anyone else here interested in a front fairing extension? Appropriately prototyped from the box my rear rack came in I will trim it down a bit more so its not so obnoxiously tall.

I have the Prinsu molle rack coming, it will go right in front of the bins, leveraging the Fresh Air (sunroof) load bars. Should be a perfect fit.
https://caliraisedled.com/products/prinsu-roof-rack-mounted-molle-gear-panel

My design goal with this fairing extension would be to ensure air travels up and over whatever is mounted to the molle rack panel in front of the bins. Since so many of us mount something bulky on the front rack, seems like a little more fairing on the front would go a long ways? I had my bins mounted towards the front more, initially. The wind profile is much better with them moved back a foot or so, as seen here. That leaves the front foot of the rack less useful for anything taller than a couple inches, else more wind profile/noise.

@upTOPoverland it would be slick if the main front fairing just had a "tall" option, with appropriate additional bolt points for strength. Then it would all be one piece.

 

Where did you get your cases at?

 

They are the Pelican Vault 800 series. I picked them up at my local gun range/shop, but you can find them a lot of places.

 

Yeah I’m really liking the Bravo rack! Although I have got to get used to the sounds that branches make when dragging across it. Was a bit of a surprise the first time

 

This is super clean. What are the t slot pieces you've run the wiring through? I haven't gotten a rack yet so I'm not sure if that's something that comes with them or not.

 

https://www.thingiverse.com/thing:2666871 generic for 2020 channeled aluminum. These do not come with the rack. I did show them to the guys at @upTOPoverland so maybe they'll do something based off this design in the future?

 

ugh another reason to buy a 3d printer

 

What is better than owning a boat? Having a buddy that owns a boat! Same logic applies here

 

Does the Truss Bed Rack on my 3rd gen also fit a 2nd Gen 2015 Tacoma? I'm going to go the Camper shell Route so I'm selling the bed and someone is interested but has a 2015.

 

Yes, fits 2005+ Tacoma

 

Order #2590SY.
July 23rd.
Status update please.

 

email them?

 

Starting on alpha install this weekend, the instructions say re:groovetek, "Notice that they are scribed with DR (Driver) and PS (Passenger) identifiers." I don't see anything though (could be my bad).

I do see a logo and serial number type things on one side of each groovetek. I assume logo points outwards?

Cc @upTOPoverland

 

Drew any update on the snorkel setup that ties into the Alpha rack?

 

I heard we were going to get a sneak peek sometime soon.