Manual transmission Fan Club and BS thread (All Generations Welcome)

OP is back.......been gone too long.....See alot of the old timers have been banned around here. Looks like there was a purge that occurred.

 

100%

 

https://www.tacomaworld.com/threads...hift-knobs-at-mt.630774/page-13#post-24396596

There's a group buy going for these if anyone wants to join in. Just spreading awareness.

 

You sure know how to make shafts look good.

 

he shells shift shafts by the seashore.

Okay, I'm leaving.

 

Can I get some clams with that?

 

too f'ing early!

 

or

 

I'll give you three gooeyduck.

 

That's one for each . . .

Nevermind.

 

I had an evergreen college geoduck shirt for a long time. It was always fun when people would try to figure out wth it is

 

Saw them out in Seattle 17 years ago, was like ... "wtf planet is this? I need an adult!" (I was 25 years old then)

 

4.78:1 1st gear inbound....

 

I like it I would get one

 

Hey quit looking at my shaft!

What's that get you? That give you more of a crawler gear or trying to get it to go a little higher (sorry can never keep ratios straight and remember what higher/lower gets you, or what stock first ratio is)?

My problem is more that it feels there is a gap between first and second. You have to rev high in first otherwise you end up bogging in second when you upshift. I like that first already feels pretty good and low (I can idle in it and even momentarily come to a stop without it dying), so I'd rather second came down a bit to cover the gap better.

Also reverse gear might be the worst offender of being misgeared. Way too high.

 

I can't help staring.

 

Shaft...

 

Hola!