What Have You Done To Your 3rd Gen Today?

Hey, Bob. I was kidding about someone stealing my OEM caps. It's just, the OEM caps stick out like a sore thumb, and most aftermarket bumper companies have you remove them, so you're left with a big hole for mud to get into. These Squareone caps cleanup the look and provide function by capping the hole.

OEM Cap:





@ClassyTacos install vid:




Frame cap link here. ( @Epic3rdgen you need these)

 

Also added a USB port in the back for the kids to use and wired it into a switched fuse

 

Yeah I’m think I’m gonna go that route too. Didn’t realize how shitty these looked already and haven’t been installed but about a month

 

The screw on the door is what holds most of the other gas cap holders in place. You may be able to cut a washer or bend some wire and secure it behind the same screw to make a hook.

 

You have more kahonas than i do...

 

Yeah, I had that thought too, but wasn't sure how long that screw was, or if there was actually anything out there like I'm looking for. It could end up being the solution.

 

No harm, no foul. Took it with the spirit that it was intended.
Mine looked fine to me and I was just there when I did my skid plate and Demon hooks. Didn't understand why they needed replacing.

Prior to mounting my skid plate I didn't even know that those were present.
Either way it's all good.



.

 

This is my aux panel installed in the LS cubby in the box.

 

I originally saw them from a guy in Hawaii, only large set I’ve ever seen, so I messaged him to see if I could purchase a set. When he shipped them, he printed them on vinyl in all separate pieces, so I would’ve had to stick each and every little drop-shadow piece one by one...

Eventually I called my old graphics buddy here in Sacramento, and we designed and printed a single custom set on clear vehicle vinyl. I think they came out pretty sick.

 

Nice! Do you have any more photos of how it's all mounted and wired up?
I was planning on mounting a switch plate, usb/12v outlets, and +/- posts onto the door of the cubby but this seems like a way better idea.

 

Primed and painted said bracket for final installation. Also replaced the battery with another Optima Red 35 as a precaution before winter, because the old one is more than 5 years old:

 

A usb device left plugged in isn't going to drain your battery. My car's usb ports are always active and I have devices plugged in 24/7 indefinitely

 

Installed Archive Garage rear wheel speed sensor skids. Surprising how much dirt is trapped in the sensor connector!

 

It's been a long time coming but I finally installed the CaliRaised Amber LED fogs a bought a year ago. I butchered the stock trim pieces removing them, but other than that it went smooth.
h

 

Nice; did the same almost as soon as I got mine. Removed the galvanization with vinegar, primed and painted with enamel. I have no idea why the eye hooks come painted but these do not.

 

I posted the link in a previous reply, that was you can see the custom set. It’s a little over a foot long.

 

Love this charger maintainer. I’ve got it mounted under hood

 

You’re probably right

 

I used this. Seems to be very good quality.

Optix Smoke Black Light Headlight Taillight Tint Vinyl Film Cover Sheet - 12" x 36" Inch

Optix Smoke Black Light Headlight Taillight Tint Vinyl Film Cover Sheet - 12" x 36" Inch

https://www.amazon.com/dp/B00I4DALAO/ref=cm_sw_r_cp_api_i_I1XNFbNTY2NA7?_encoding=UTF8&psc=1

 

Love the tag.