TRD Pro & TX Baja OFFICIAL Thread...

I think they came off a regular Tacoma (and I have a Baja).

Can you tell?

 

There actually wasn’t anything special about the Baja leaf pack, it was the same as the Off-Road models

Looks like the exact replacement! There are 3 leafs plus the short overload

 

wow. thats deep.

 

Awesome, thank you so much!!


(I guess I just didn't want to replace with a Prerunner setup is all, trying to keep things stock)

 

Helluva deal for $20. I'd jump on it

 

Had mine on for a week or two, highly recommend. More power and smoother everywhere, install was easy. Can't say for sure yet, but I think MPG up a little.

 

Mine should be going on in the next couple months

 

Cool, FYSA: I'd budget about 5 hours for the install. Did a longer review of them in the marketplace thread for them.

 

Some hi res shots from my friends camera

 

Finally finished the TC 2" kit on the Baja. Sure glad the 33" tires are going on my 1st gen they look like dinky donuts on this truck lol.. So far super happy but still have a ton of work to do on this truck but it's getting there..

 

Holy fuck!

 

Only thing Pro left on the truck is the grill and the shift knob(truthfully, the. TRD has worn off on that). Oh and the black door badging. Oh, and the headlights... I still have more work to do.

 

@Island Cruiser and others on here that have way more experience than me with suspension, I need your expertise. I have a local hookup on a new set of Bilstein 6112 / 5160. This setup was purchased for a 3rd gen, but the seller says they will fit a 2nd gen, but give about 1" more lift.
I currently have the 1" TRD PRO spacer from Toytec up front (on top of stock 1.75" Pro lift) and a progressive AAL in the rear. I am running 265/75/16 tires. My goal is to stay about the same height as I am now. I do NOT want to go over ~2.75" as I do not want to go UCA's, etc.
Thoughts? Thanks fellas.

 

Take a measurement flat ground to the fender. Install the new set up and remeasure. You should end up about the same. If you are higher you can lower the setting to where you want to be. If you end up much higher then intended, give it some time as the suspension will break in and settle.

 

I’ve been wondering the same thing! If the clips are set for a 1.75” for a 3rd Gen, it “should” net 2.75” for a 2nd Gen. I emphasize “should” because of my encounter with the 3rd Gen Pro Fox’s lol

 

Yeah I’d be anxious to see the results. My measurements were the exact same from my Baja suspension to my TRD 3rd gen pro suspension.

 

TRD 3rd Gen pro suspension WITH top plate spacer lol not bare bones like what I experienced

 

Yeah I had and still have the top plate as well. Wish it worked for ya. I do like it on my truck.

 

So, "on paper" it looks like it should be a good swap. I guess I'll try it and worst case scenario it is a $1k mistake. LOL.
However, I will be powdercoating the coils red because I am a PRO and I love my red coils.