What have you done to your Tacoma today? 1st Gen Edition

I ended up doing this.

 

You're assuming they would be human archaeologists.

 

Looks like a nice size bottle. I'm not sold on mine yet. But I'm going on a trip this week and needed a sprayer again since the snow has finally rolled in. This cost $0 and a solid 15mins of which I wasted 10 looking for my smallest hole saw haha.

Right now this area in front of the airbox is highly sought after by my winch parts so I may need something I can package farther down on the fender apron.

 

Be careful you're on the same wavelength as Jaxon now

 

I just saw that. A very scary thought.

 

thats good to hear. Im going to go that route I think. Have had some LED housings and they have been okay. But ice up too much.

Think I have some 100w H4 bulbs for them though.

 

you can only go down from here

 

At least he isn't welding shock bodies

 

Well if you're used to the LEDs you might not be amazed as I was coming from the sealed beams but they're definitely solid, I'm sure they'd be even better with those high wattage bulbs.

I stuck with 55/60 until I have an aux fuse/relay box set up because rat's nest wiring around the battery will drive me insane

 

There’s definitely far worse than me

 

Still light enough yakety sax it off the truck. Maybe I can get it painted this week...

 

1st half of my 4x4 conversion done

Everything went smoothly until i sheared off my fucking abs port bolt

 

Been thinking about it but the abs light on the dash will drive me crazy ahah

 

That comes outta the cluster pretty easily. But make sure you find a way to keep that sensor from falling out because it'll let shit into the bearing otherwise

 

I just bought a couple bit extractors so I’ll see if that works. If not I’ll just jb weld it lmao

 

Any idea of how much it weighs?

 

sline.spraking of ABS. So if mine is disabled via fuse, then no reason to have those lines righ? I may have torn one when my spindle cracked

 

Frame weighed in at 205ish, and then the aluminum deck is probably close to 70.

 

did that break on disassembly or assembly?
Wouldn’t drilling out with an extractor introduce shavings into the bearing?

 

Took her into the snow. Only had to get pulled out once when I thought U-turning in 4 feet of snow was the move