What Have You Done To Your 3rd Gen Today?

Well believe me it's not all that easy. It was my first time so I just read up on it. You can buy kits on Amazon. A lot of work for a little piece but just wanted to see if I could actually do it.

 

How difficult is this to apply?

 

$15 Lighthouse LEDs 12v 0805 Chip/Micro SMD Wide Angle Pre-Wired Blue LED - Ultra Bright (10v, 11v, 12v, 13v, 14v, 15v, 16v, 17v, 18v) (Pack of 10)

https://www.amazon.com/dp/B07D24DQML/ref=cm_sw_r_cp_apa_fabc_0CJZFbC5H89WF?_encoding=UTF8&psc=1
It's small but a little brighter than you might think. Probably too bright for most.

 

Ordered the same Husky liners for a 2018 and had to add the anchors on the passenger side to keep those in place. Now both sides fit like a glove with no gaps anywhere, unlike the WTs. Absolutely love the Huskys.

 

Battery powered or did you wire it up?

getting a good fit would be the hard part, sla printer could spit those out quick once you had that.

 

Yep. 30 days away from 4 years and I've 16,000 logged.

 

Well that's a start. Brightness issue can be solved with a resistor easy enough.

 

These can run on 12v so they can be wire to the truck.

 

Changed out the bumper caps from chrome to paint matched. Looks way better IMO really happy with it. Not sure why they even have chrome bumpers on some of the trim levels.

 

is the plastic piece easy to come off?

 

After 3 years of owning the truck, just discovered there is an electric heater that operates the defrost when the engine is cold. Very handy with frost on the windshield. This may be the best kept secret on the 3rd Gens..

 

Beautiful. That is where I want to be in life in the next few years. The Mav2 and pro is awesome. I used Hasselblad cameras in the Navy and there is no better optics (except Leica). Thanks for the convo and I'll let you know how it goes down soon.
Zim

 

There should be a picture of the installed finished product near the bottom of my original post. Here’s one before I clipped the dash trim back in.

 

Looks great! So glad they were able to get it repaired for you. I have had a few close calls with wildlife on the road. That would be a bad day!

 

Really? My shell ARE shell is too much for my stock leaf springs

 

Thanks. It definitely could have been much worse and I'm thankful it wasn't.

 

How are you guys anchoring your passenger mats? I have a 2017 and it SUCKS they don’t have factory anchors built in..

 

Hey does the AP gas tank skid use the OEM straps?

 

Perhaps this could be a solution. I don't have a topper but do pull a heavy pop-up camper and am quite happy with the performance of this product.
https://activesuspension.com/

 

You can buy OEM mounts that you install into the carpet, but then you need to buy a new oem passenger side mat. Otherwise many use universal floor mat clips, or you can use double sided carpet tape.