BigDaddy’s Buzzed Shop Builds, Beer, Smoking BBQ, Grilling, Cake an BS

Good morning sir!

 

That’s my favorite thing to do! They don’t know what I’m a pro at but I am a pro if anyone asks.

 

Damn skippy. They don’t specify what you’re a pro at.

 

I need to touch up the lines and couple spots, and add the star...but its a wavy flag. Bout the third try on this particular board

 

That's nice!

 

What compound are you using?

 

@medic2230

 

thanks!
Hard to see the waves in pic but it looks nice in person. It will hang like this.

 

Give me a couple min and I’ll grab a pic for you.

 

I’m about ready to bitch slap an engineer. Busted into the rv heater to test sensors to see why it’s not firing. Finally find the limit switch. Guess they figured let’s put one of the most problematic sensors in as hard to get to location that we can. Then let’s silicone the entry piece to the metal so they’ll have to buy silicone also. FFS

Just so happens that 2 extensions isn’t enough to reach the only thing on the heater that has square drive screws in it. Really?!?!?!

Pic for my struggling pleasure.




Yes, that’s the outside exhaust tube for the heater the photo is through.

 

I liked square screws for about 1minute. Till they strip out like cross screws.

 

Square screws are as stupid as straight screws.

 

I like them. I’ve used thousands of them building and installing cabinets. But why the hell would you use two on something that everything else is Phillips?

 

the only acceptable answer

 

These two. Use them with a dual action random orbit polisher/buffer. With yours you might be able to get by with just a polishing compound. Make sure to wax when you’re done.

Compound:





Polishing:




Buffer:






Plus a gracious pic of the Ram.

 

Like those too. Unless I’m using the 5/8” drill and it tries to break my damn arm when it gets tight.

 

True...but they're ohh so good. We have em on all of our Hilti stuff. I just use a lower setting on the clutch, especially since a lot of em go into plastic