Shop Time w/T.W. Friends

the handle is about 24" wide and they want about 14" up the shaft
that's a fair bit of waste for dipping

but it's probably cheaper than PlastDip

 

I would think what Dean said with flex seal in can. Could let it dry then dip it again for thickness desired, maybe.

 

May could brush it on, be worth a try.

 

Or maybe spray flex seal can?

 

brush marks won't fly
I'll try spray can
I wonder if past has enough working time to smooth it all out. maybe with a spray top coat

 

I’ve never messed with flex seal, I know @StayinStock has. Any input about it Bob?

 

Same here.

 

we only got 2” of snow from the last storm, but the kiddo asked to ride, so here we go!

 

It's total crap! I had a very small hole in a gutter on my shop, tried flex seal....long story short, the gutters went in the trash.

 

I’ve always wanted to go ride sleds somewhere, I’m too old now! Looks fun.

 

So not two thumbs but two fingers?

 

Yes! 2 fingers up! Wanna buy a can from me?

 

Not now after your review. Would have before that

 

you’re never too old to ride sleds! Well, maybe in your 90s. I have a spare one, so if you are up this way just let me know!

 

just to old to go fast

 

sleds are fun till you get stuck. I rode an old one barely started, it was fun for the little bit i used it for. I never could say it was worth it to buy a new one. I used my atv a lot more than i would have used a snowmobile

 

Going fast doesnt bother me, crashing or getting stuck does.

 

We have a really good trail system up here, so if you stick to it you rarely get stuck. The down side is there are plenty of boneheads here who ride on ice that’s too thin, or the wrong side of the trail, which is frightening.

 

Played in the snow with brother joe and family, pulled a log off the dam with the taco until it hit the hill... taco no match for this... grabbed joes power wagon and yanked it out Was a FUN afternoon for sure

 

Warming up before heading home