What Have You Done To Your 3rd Gen Today?

Thank you for the kind words, I'm right around 3.5 to 4 inches. Kings Resi set up with clickers front and rear, Camburg Ball joint uppers, DirtKing Ball joint lowers, HD OME leafs with Bolt flip kit. Some other odds and ends here and there, bump stops, extended brake lines stuff like that. I did a cab mount chop and fender trimming on the ends. I like the stock modified look so I don't want to butcher up the fenders, trying to keep as much as I can. If you're bored You can check out my YT channel for all my mods/installs. Its in my Sig. Thanks again.

 

Holy fab job. That thing is serious. Nice work.
Zim

 

Bolted on som RCI sliders.

 

I was bored this morning so I installed my awning onto my Prinsu. It’s my old awning from my Tahoe and I was waiting to install until my RCI bed rack came and I got my rtt on it but I was just too antsy this morning.

 

Nice! Diggin’ the bed side decal as well!

 

Thanks

 

Can you snap a pic of the rear center head of the bottom? I may put the og cover back on that rear if that’s the case

 

Hope this helps! Let me know if you need better, different or more

 

Thank you, nope that was it. Your rear cover was removed prior to the katzskin, the visible foam around the posts.

 

Wheels are here!
Merry Christmas to me

 

September of 2018:

Today:

 

Perhaps just cut some black felt material with a hole in it and stuff under the new covers?

 

Just for winter. Will switch back to the stock tires this Spring.

 

Installed a cheap ebay chase light today. Now I just need to find someone to chase me around the desert!

 

Installed my headlights about 80% of the way. This has been a bit of a process but I’ve been working with a couple different members here to get the TRD headlights working on my base model. Still need to finish-up the turn signal bucket wiring and mount the M LED 2.0 drivers.

Here’s my DRLs run at 50% brightness to reduce glare

 

Up in Edmonton we didn't see any!

 

Any info on that basket and bars you have there? That's something similar to what I want to do using my bed-divider.

 

mounted up a shovel today

 

Oh no I don’t care the the foam is exposed around the posts. I wanted to make sure that’s how it’s done normally (or if they left the removesble rear covers on). If the members pic didn’t have foam exposed then I would of removed the katzkin reinstall the factory cover and reinstall.

 

I finished the home-built rack today on my new TRD Sport LBAC manual. It's for carrying building supplies and paddle boards and the 30' long mast for my sailboat (with an upright bed extender mounted in a front hitch receiver). I couldn't find anything ready-built that I liked. They were too tall, and didn't support removing the aft cross-member for loading tall items. And it bugged me that the aft parts of the racks seem to usually be a foot or so from the end of the bed. The lower ends of my vertical members are all attached to the hard points for the tie-downs with home-fabricated aluminum brackets. Cross members are thick-wall 1.5" OD aluminum pipe with fire hose for padding for the mast and paddleboards.