Tacoma - OVTUNE - VFTUNER - Update Info and Original Development

So now I have to make an additional purchase to access the 2.0 files I was already supposed to own?

 

No, just email us with your ECU ID

 

Anyone care to help out. I have been trying to load a tune using thebflash tool on 1.3.2 but keep getting “completed unsuccessfully”. Ignition is off with everything else turned off. Battery is over 12.3. Im able to identify, just not read or flash.

 

You did 2 presses (ignition on, engine off)?
Also double check the ID shown in identify matches the ID of the file you are trying to flash.

 

Yup. 2 presses and id shows 04b33. I was able to flash a vft tune on friday and this same issue popped up once during the process. But now I cant even flash any tune.

 

Wait for the master key, your reg ID will stay the same. The master key will be in the email responding to your order.

 

Are you back and sending out master keys?

 

yes I have been.
Check spam folder if you are expecting one, unless you *just* recently ordered

 

Anything about 4runner tunepacks??already checked spam folder....ticket 22878/22795

 

how do i update vftune? i dont see anway to do it other than downloadinf and installing it again

 

That IS how ya update

 

gotcha hahaha. i hate it when the obvious is the answer. im used to everything being complicated haha

 

I downloaded it, version is 1.2.5.1?? Thats not right.

 

Have you seen this ? .... https://forum.vftuner.com/forum/toyota-3-5l-2grfks-development/271-vftuner-releases

Announcement
vF Tuner version 1.2.7.8 release
If you have vF tuner, please update to this version.

- new ECUs available
- new tables for Tundra, Tacoma
- New AlphaN controls - Tundra 2018+
- Beta Support 0CM52 2016 Tundra FFV
- new tables for scion tC (21272 support)
- Access for scion tC owners to update their calibration to 21272
- new tables for Highlander / Kluger / new ECUs
other useful changes

 

You downloaded it today and somehow got that old version??

open vF Tuner and click about and check that version should be at least 1.2.7.7

 

That is what is shown in the Properties of the Installer file. It would actually be 1.2.7.7 at least in Help / About.

 

I’m getting 1.2.5.1 also

 

Amazon strikes again !!!

 

In Help / About or the EXE Properties?

 

So actual version is 1.2.7.7 after I loaded it up.