Fitting 35’s with minimal trimming NOW ADDING LONG TRAVEL AND 934 CV’s

I am looking to plate the rear of my frame in, will the fuel cell work with that or would I have to leave it open where the cell sits?

 

Curious about the skid...
-does it work with or replace the one that comes with the kit?
-does it work on 2nd gens
-how many monies?

 

Same, you may as well add one to my order

 

@81Trekker it seems like you've touched on this before, but I can't find the post. How well does the +2 perform with stock besides and 35s. It seems you said you don't have to do an excessive amount of cutting/swap to glass. I have -12, 4.28 BS on 17×8.5 wheels. I'm trying to figure out just how deep this LT rabbit hole really goes.

 

The fuel cell has integrated plates that completely box the frame in. No need to weld anything in

 

Works with the existing skid and works for both second and 3rd gen, don’t have a cost yet

 

You will have to cut the fenders for up travel. Ideally you would have a 0mm off set for that set up but -12 will only be a 1/2” wider

 

The new front skid plates will be available in the next couple weeks. 3/16” steel and bolts onto the stock front cross member. For guys that already have the LCA kit you can send in your front cross bar and we will weld tabs on at no charge otherwise we will include tabs for the guys that want to weld them. $249 powder coated

 

Def something to think about. Seeing the pictures makes me want a front crossmember delete kit, that has the square tube to make the new high clearance cross member, and the new skid that attaches to it similar to the one seen here.

I've been eyeing mine for a chop, and integrating the CBI bumper to the cross member for better support at the bottom edge (it is lacking there) and a skid to attach to the LCA kit just like that. Would love to have a kit instead of inventing it myself though!

 

Can this be included in my order? Or will it require modification to the current order.

 

I can add it no problem

 

My man!

 

All trimmed up

 

Too sexy

 

Couple more just for fun

 

So the LCA pivot design has been upgraded to now include an additional front skid?
Will this be available on the website in 1 month? At extra cost or included?
Just checked and didn't see it (I'll wait)
Am glad I didn't order the Pivots quite yet because now I should probably hold on until the revision comes out

 

It’s an option available now, $249 read my post on the last page

 

Harry, You up to designing and building a front bumper with winch instead of modifying someone else's for 2nd gen? Of course this would be to go with your lower control arm mount. Then build skids for trans/transfer case and sliders?

 

Very clean trim job! Are those 285s?

 

295’s