What Have You Done To Your 3rd Gen Today?

So I hired on at a Surveyor that was using Autocad Land desk top, I think it was 10, lots of F key crap. Anyhow a few months later, someone hit the wrong key and Autocad called. Asked where we got the other 18 copies of the software the company was using. LMAO.....$65,000 later, we had the newest version, another lawsuit, and some mad company owners. I lasted 3 years and bailed in 07.
Zim

 

Installed the Victory4x4 molle panel on the passenger side before Christmas and finally received all the molle gear to install. Not sure if I need to put the one on the driver’s side, but I’m sure I could find other items to mount.

 

I like it, maybe need a Batman emblem on the grille instead of Toyota.
Much better than Meso bling!

 

The price you've found is good, but I've seen people here talking about a pair of anchors in the double digits so I like to mention the Fastenal d-rings as a choice. I wouldn't worry about any rated strength above say 500 lbs too much because I'd bet if you come close to a couple hundred lbs per you'll pull your bedrails off. Since I don't want to put too much tension on my stocker plastic anchors or the 3/8" eyebolts I have in the bedrails I've mounted two d-rings in the fore bedbolts. I either use them like normal or run chains between the fore and aft d-rings for multiple tie-down points.

Some of those t-slot anchors can get pricey too, so I use ground down 3/8" electrical spring nuts from HD like a lot of guys here. Like 5 for $5.

 

Tacomas forever 20 years apart

 

Love the 1st Gen. Mine was a black 2001 TRD AC.

 

Just got my 40” tires mounted up. Tomorrow I’ll get an alignment. Long travel bracket lift 3 link. I just joined the club. These tires are massive! I think this is the biggest independent suspension tacoma in country now. And I’m still not finished with mods I want to do... cheers !

 

I think it's the first time I had to undo/cancel an order to do temp roof repairs till insurance comes through. New leafs will have to wait.

 

That sucks man

 

put on the pro skid**

 

Where did you get the molle case for your leatheman? Mine fits but it’s rigged up a bit. Yours looks nice and secure

 

Is there an after picture?

 

lol wait pro skid

 

Stuff happens. Just want to get it fixed before the snow arrives next week.

 

I don’t blame you one bit. It happens, the roof definitely takes priority.

 

you did

 

Ha ha. Nice looking ride.

 

Definitely a great looking rig and One of a kind. Nice job.

 

That truck looks amazing. Be honest though, you had a hot wheels truck as a kid that looked very similar to that, didn’t you?