1st Gen Lunchtable Thread - General Discussion

Opted against the Delta VS one?

 

How do they attach, I'd leave it in most cases, usually the way the solid axle ones work, they pivot so they don't limit flexability

 

Though a lot of guys keep it and just run either custom end links or 2nd Gen 4Runner end links



I've heard of a relocation kit or something but never looked into it.

 

Just yeet the sway bar, be a man

 

Just finish your Tacoma and jump on COD with Todd and I...



Even better, yeet your Tacoma project

 

@Empty_Lord I don't know if you saw but my panhard bar is at a slightly steeper angle with my 890 springs installed now.

 

I'd extend the links cause the 4 runner rear is notoriously tippy. Looks like is uses the same link style as the early 80 series, so it should pivot plenty to keep from limiting travel

 

Yeet the linked setup, go leaf spring.


Yolo.

 

That's been on my mind as well; just longer links and retain some stability.

 

WHAT JUNKYARD LEAF PACK CAN I USE

 

Any you like. Junkyard leaves are great if you're comfortable building a pack

 

Have you seen Eimkeith's start of a custom 4 link for the 3G4R?

He hasn't posted any progress for awhile but it caught my attention.

 

No I didn't. The gas tank is probably in the way of a triangulated four link, but that would be ideal, then you could yeet the panhards.

 

He has a mod for the gas tank too seeing as how the drive shaft can make contact during some really flexed situations.

 

TOO FUCKING FUNNY at the right moment

 

Reverse triangulate, no gas tank interference and can run longer bars.

 

Best I could get tonight was a mix or Erickson and GRIP.

I've been putting off buying a set of Macs straps. They are the real deal. Instead I paid the same for some junk that probably has a lifespan of a year or less