What Have You Done To Your 2nd Gen Tacoma Today?

How much of the fender flare did you cut off here?

 

could be a higher demand for 255/85

 

Installed my russian arctic fender trim... i wanted some type of lip because my fender flares are gone.

So far i like them, pretty durable too already crunched one and it went back to its final form. Lets see hoe they hold up in the long run

 

Not too shabby. Got a link?

 

They have 2 sizes, XL and original. I went original i didnt want it to stick out to far.

You need 2 packs for all 4

$45 EZ Flares - Universal Offroad Flexible Foam Rubber Fender Flares 1" Extension

https://www.amazon.com/dp/B071G6FGM6/ref=cm_sw_r_cp_apa_fabc_9AicGb9YH5023?_encoding=UTF8&psc=1

 

Holy shit I’m finally done putting these bead locks on.

 

Not the sexiest mod, but I'm looking for that longevity. Drained and refilled the transmission fluid. Went with Redline as recommended by many on TW.

 

About 2 inches

 

It's not bad, lots of straight edges. Some steps would've been nice with another set of hands. Its 3/16s so you get to weld on it nice and hot.

 

Best part is you get to choose how close you want it to the body of truck and your angle and height of the hoops. Being only 500$ I might sell this one for cheap so I can get another one and take my time and do a little better job.

 

Heat shrink tubing around the front/rear reservoir hose clamps. Minor mod, but it cleans up the look and the clamp isn’t digging into the reservoir.

$8 XHF 3/4" (19mm) 3:1 Waterproof Heat Shrink Tubing Marine Grade Wire Cable Adhesive Lined Tube Insulation Seal Against Moisture Corrosion and Air Leakage, 4 Ft Black 1/0, 2/0, 3/0, 4/0 Wire

https://www.amazon.com/dp/B07FP6ZT8Q/ref=cm_sw_r_cp_api_glc_fabc_vvocGbPC10KWJ?_encoding=UTF8&psc=1

 

Damn that's a good idear

 

dialed in my water pressure system under the softopper. always ready to go now with a flip of the switch. sea-flo pump is mounted in the bed cubby.

 

Can you elaborate a little more on your setup?

 

i got this system installed a few years ago:

https://www.tacomaworld.com/threads...or-the-2005-current-toyota-tacoma-obw.453005/

Great product and the install was smooth. I vouch for this guy. i just modified it a bit yesterday, hardly at all actually. secured that 7gal water container to the corner of the bed. it's easy to refill right there just open a corner of the softopper. ran the water source line behind the the softopper frame bars so they're out of the way and used a quickfist to hold the soaker. all this can fit in the bed cubby if i want to.

 

Stealing this idea!

 

Same! Think I found something more appropriate for Kings too.

 

Been looking at kings. Not quite ready to buy yet. The current set up is just fine. When I do spring for my kings though, I think I’m gonna go all out and customize them with custom colors.

 

Do tell?!?