What Have You Done To Your 3rd Gen Today?

I don't think people would mind on this thread.

 

Here you go!

 

Appreciated! I can never see too much cement georgeousness! But I’m biased:

 

How did you de badge the tailgate. Fishing line. Any paint fade

 

Lift kit on the cement?

 

On my truck I used a heat gun and goof off. Heat it up and you can pull it off with your fingers, then use some goof off to clean up any glue residue.

 

Love the look of the amber.

 

Which one?

Mine has OME 888s front and medium dekars on the rear with 5100s all around.

 

Ok sounds like a plan

 

You have my interest... These help with load, I assume? And how is the install?

 

Just ordered my falken wildpeaks off Amazon they’re on sale

 

I always use a fishing line to remove the badges. Goo Gone and Wd40 for adhesive removal.

 

Installed some new SCS SR8's, 17x8.5 -10 in matte gunmetal with Nitto Ridge Grapplers in 285/70/17

 

Added some bling to the control knobs.
Can't do radio knobs until a generous TW member is willing to send me the OEM ones they took off from a 2016-2019 Entune.

 

I have 2020 knobs I’d give you if that helps for any RnD

 

The radio changed in 2020. Thx for the offer though.

 

Only problem is that mile markers often aren’t really a mile apart. Maybe if you average over several, it’d be close enough, but GPS should be more accurate. Or, use a GPS to measure how close to a mile apart the mile markers are, then you can figure out exactly how much time it should take.

 

I have the OEM knobs off my 2016 with the basic entune. They’re black with a silver ring on them. I replaced them with the MESO knobs.

 

Finished installing the OME dakar medium duty leaf springs

My factory springs were sagging from the weight of the camper shell and the gear that lives in the bed.
Center of hub to fender measurement increased 2.5 inches

 

I like the SR5 decal you installed. This has encouraged me to purchase the same decal that was on my 2001 TRD OR to replace the TRD OR decal on my 2017.