What Have You Done To Your 3rd Gen Today?

I have a bed rack with a rtt and some other gear so I’m waiting to see how much sag it fits before I add the 1/2” shim. I’m also planning on purchasing the Eibach Coilovers 2.0 in April for the front to replace my front 5100s so I guess I’ll just be able to adjust the front to account for the sag.

 

I’ve been running 265/70/17 w/ stock suspension for 2 years and no rubs. You will not have a problem.

 

Thanks for the advice. Home Depot had it and it worked right away.

 

Well, its time to bid you all farewell. Thank you all for the helpful information and great conversations. My plans in the future include a toy hauler and as most of you know the Taco has a small tow limit. So I traded in my Taco (29k, not bad) and upgraded to big brother Pro, time to sign up for the Tundra forums!!!

 

Very nice but why not wait for the new Tundra?

 

Glad it worked out.

 

Picked up my Foxs' from getting rebuilt, got a used set of rear Dakars, ordered some 33" Kenda Klever Rt's, and screwed around in the snow.

 

Installed my OEM remote tailgate lock today. Super easy to do. Pretty fun install! Used this great instruction video: https://youtu.be/gz-8j4S3Dkw

 

It’s going to make a big difference. You’ll be glad you did it!

 

Nice, I like the way it breaks up the white

 

Too funny

 

I have the tall and short switch blanks but neither one fits. Thanks though.

 

Thanks for the confirmation, just put my order in for some vent rings and chrome delete...climate rings out of stock... THANKS!

 

Just a few little things.

Cali Raised



Hood Protector weathertech

TRD Logo from Tacos for cheap

 

I would order a new OEM usb-
audio Jack from the dealer and be done.

 

Might do that if I can find the part number until @MESO starts making the lower console switch banks. I found the panel on his site.

https://mesocustoms.com/collections/3d-printed-products/products/tacoma-lower-switch-panel

 

Got my @EasyDoesIt Compressor mount all lined up and ready to wire in. Looks great!

 

Installed demon brackets outboard of stock skid plate. Working on a design to reinforce this location, at least tying it in to the frame vertical. I don't expect to get it to recovery point strength, but maybe an anchor point to belay a stuck jeep

 

Adding some protection. Cleaned, etched and 2nd coat of por15 in this pic. About 3 hours later put matte black top coat on. 3 or 4 more coats go on today/tomorrow.

And por15...that shiat doesn't come off so be careful if you use. Some how it ended up on my friggn neck and back side of arm.

 

Nice, where does that mount?

Nevermind, I see under the seat.