Tonneau Cover advice....

Thanks! I will keep an eye out

 

$460 on a Black Friday deal.

 

Yes sir! The cover hardware gets bolted down on the sides on three spots, so it still leaves plenty of room to use the remaining bed rails. I really like your setup, very clean and not intrusive. Should work just fine with the cover.

 

The Truxedo Lo-Pro looks almost just like this when rolled up for those curious about how much bed space it opens up. Soft covers are more of an "out of sight, out of mind" type security over a hard cover. Just get a decent setup, take care of it, and you will get your money's worth out of it.

 

^^^+1 for a lomax stance from @truckalter ^^^

super impressed with the cover and Luke had a great price and super fast shipping

 

This is the cover I have and it’s been a journey trying to get it not to leak.

 

That sucks. I haven't had any trouble out of mine. Even going through a high power automated car wash, I don't get anything more than a dribble in the corner.

 

Hmmm. Yea it’s strange. Install was a breeze. I’m going back and forth with truxedo. Water comes in through the corners by the cab/bulkhead

 

I'm assuming you used the extra foam pieces they provided and put them in the right spot? Just build up that corner with additional rubber weatherstripping and that should eliminate most of it.

 

Yep. Those two foam pieces. Been trying to build it up with butyl tape. Fixed it slightly but still coming in. Luckily it runs under bed mat until I figure it out.

 

Good luck brother. I hope you get it figured out soon. I really like the cover and it's perfect for what I need/want.

 

Thanks a bunch. I’m sure. And if not.. I’m still keeping it. Will keep it dry enough LOL

 

Here's my Lo Pro rolled up. If I had a 6' bed, I may have considered a trifold, but with the 5' SB, I want/need full access to the entire bed. Easy install using 3 bolts in each of the bed rails. There are 3 aluminum crossmembers that get rolled up with the Tonneau Cover. I see very little "flapping" at highway speeds. And there's room on the bed rails for the cleats.

 

$485 then $50 rebate ...worth it!

 

I have a Powertrax XR One. Absolutely love it. Got it on Amazon for only $1090 shipped, a little more than half off its original price.

Their customer service is also great.
There was this odd gap at the canister, creating an imperfect seal on the passenger side between the canister and cover.

Retrax sent over a whole new unit, at no charge.

 

Please don't pay that... shoot me a PM

 

Has anyone said Diamondback yet?!?

 

Pm sent

 

Thank you so much!

 

I'm new to Tonneau covers. My previous Tacos were all open bed. My biggest issue with the OEM cover is that I can't carry any MCs in back because it is only bi-fold. I didn't order it , it came with the '20 leftover that I scored. I may need to swap it out with a roll up.