Let’s see some subwoofer setups!

Sill have it. It hits hard. I usually don't even mess with the bass knob because it is plenty

 

thanks are you still able to latch the back seat?

 

Sits below the child latch. The only issue was the middle seat bar but if you remove the plastic off the back seat it will tightly fit in....which i liked because it will not go anywhere. It thumps. I am more than satisfied with the sytem. powered by an old BD1000 Rockford Fosgate Amp with the gain turned way low.

 

nice probly go with those seems like more bass then there stealthbox and each speaker is rated for 250 watts but I heard they will take more

 

that’s a sweet setup did you make the box?

 

Nicely done!

 

Did you have to take seatbacks off to get them to lock back in place when up? Also what year truck?

 

Getting closer.

 

Just finished the box for the rear passenger cubby using 5/8” mdf, was wondering were you guys were getting your speaker carpet from?

also used wood glue to seal the cracks was wondering what the best material for keeping it air tight was?

also best mounting place for the sub suggestions middle or sides does it matter or affect the sound?

wasn’t sure so I made two boxes

thanks guys

 

Just finished installing

 

Ready for install!

 

You needed the voltmeter to tell you you at 2 ohm?

 

It is always good to verify you ohm load before plugging it in.

 

Well, the subs can't talk, so yeah.
Was just making sure I had wired it correctly.

 

If you actually need a voltmeter to check your bridging or series running you probably need a professional to do the install

 

Not being a dick just being honest

 

Go fuck yourself. Just being honest.

 

Point made. Lol

 

Nah. You’re being a dick dude. The point is, he’s NOT a professional installer so he wanted to confirm what he did. If he was a professional installer and needed to confirm, that’s a different story.

Also, you don’t “bridge” a sub. You run them in parallel or series. You bridge an amp. Before you go calling people out, you should prolly at least know what you’re talking about.

And no, I’m not a professional installer. I just don’t act like a dick to people who know a little less than me.