Colorado B.S. Thread

$90 is a way better price than $22. Thanks for posting these!

 

Lol. I was thinking the same thing. I am all for buying quality but I'll spend my money elsewhere. I can buy 4 sets of the cheap ones for the same price. I do like that retro hoodie...

 

It's the Expo/ Gram life for me

Dammit #EAF!

 

Couldnt justify the $100 after tax and shipping

 

I only buy American made by gawd!!

 

Jeez. Sounds like snusnu is not what is killing you at the moment. Hope things turn around. When it rains it

 

Is there a cheaper version of this out there?
https://geartechcustoms.com/shop/ols/products/toyota-tacoma-fend-x-wheel-liners

Cheap version/solution for those that cut the plastic wheel well parts off? Pretty sure I just ripped all my out haha

 

cheaper version would be to buy a roll of rubber and cut to fit. Ive looked at home depot and lowes but couldn’t find anything suitable. For $24 to replace and be done is a no brainer for me.

Id rather spend time and money on other things

 

We have a weiner!

 

yeah that the inner part for sure, I was more so talking about the wheel well themselves where the plastics used to be

 

i was going to cut rubber to fit that too

 

Fucker fires with starting fluid, but gets no gas. And it's beyond cold out. Torched the fuel line for a few minutes but can't get to it all and don't want to burn the fucking thing down, just yet. Checked the EFI relay, looks like a relay. Without a second set of ears I can't tell if it's relaying or not.

 

I'll be pissed if it's the fuel pump for various reasons, one of which is I just filled the tank.

 

The last time I went to ToyTec they had fender liners in stock. Don't remember the brand or price, but you could give them a ring in case you want immediate satisfaction.

 

Proper fix is cut fenders, tub with sheet metal and use zeus buttons like the prerunner guys.


Lmk what you find out

 

@Deathbysnusnu - when is the last time you replaced the fuel filter?

 

i just called toytec and they only carry rad rubber splash guards not fender liners

 

Gas freezes at like -50° to -200°. Just after fill up could mean you possibly picked up some water. Might try some isopropyl alcohol. RIP to the fuel pump is likely though given the description. Check for voltage 1st, I've seen some issues with the circuit opening relay circuit.

 

I think once you start cutting the plastics and fender liners you are in the territory of doing something custom with a piece of rubber. Other than covering the intake and aesthetics, I saw no compelling reason to worry about the wheel wells. It's all sheet metal.

 

I dunno, prolly when I had the fuel pump replaced. Which may have been never since I can't find any receipts on it. I thought of that too, and will start there first. But it should still sputter a bit. It ran fine before I filled it, I drove all over town this morning, several stops for work related shit, then bought gas on the way home.
Went across the street to get groceries. Started and died in the parking lot, thought maybe it was just me. Went to the liquor store, it coughed once on the way there, or maybe I thought it was a patch of ice. It didn't start again after that. Lot's of cranky, no starty.