vF Tuner for the 3.5L Tacoma

tried downloading update

This XML file does not appear to have any style information associated with it. The document tree is shown below.
<Error>
<Code>AccessDenied</Code>
<Message>Access Denied</Message>
<RequestId>XS4WXJZVDDE48K80</RequestId>
<HostId>
Wh2u52XB0aE+YBA6a6t+gtCL0DF9/57JCyw4Dg5MICyrBS6+okOQbVSagrKj4/XsdFIOyNTPznk=
</HostId>
</Error>

 

it's still uploading.

 

oh ok wasnt sure if it was done yet thank you for quick response

 

I have been getting this message for the past 3 hours?

 

we are working on adding in TSB - Updating into the flasher

We will definitely get that part clarified. When the prompt tells you that you're finished, it's all done flashing. Can disconnect and good to go.

it's being updated at the moment, but previously, it's likely due to so many people trying to update at once

 

Thanks, Mat. Once “Prepare ECU” is successful do I have to flash a file? Is the ECU essentially back to stock? Also how to reset LV and AT with new flasher? Tks.

 

right on definitely excited im happy i joined the crowd i have more passion for my truck than before

 

"prepare" ecu only does a few things
1. gets the ECU information (VIN/ID/etc)
2. communicates with our server
3. Tells the ECU it will be flashed

that's all it does. Doesn't flash anything, you can disconnect and stop, shut off, do whatever, etc.




Reset AT, Reset LV has been temporarily removed. They will return, with even more features. But not until we have some clearer information about when they should be used. Because those two buttons have caused so much confusion for folks, and so much bad info about it on here.

 

downloading

 

starting update

 

- All should be good for flashing - and I have tested here again.



Thanks all. Any issues >>> Zendesk.


More goodies are on the way. Especially for MT folks. Lot more Throttle control / related tables.

 

so i installed update and did driver update so now I can head to truck and flash update?

 

@OVTune...YOU are going to need a couple of beers, whiskeys, or milks...what ever you drink after today!! YOU ARE THE MAN!!!!

 

if you have a tune file or update you've been working on and want to flash sure

 

Do you have to run “Prepare ECU” every time you want fo flash a tune?

 

yes

 

Thank you, Mat for patiently answering any and all my questions. Best, Jim

 

green progress bar doesnt finish???

 

it's OK, as long as you get the prompt that flashing is done. Shut the truck off, start up.

 

There will be a little left but you will get a message saying installation complete...turn off power. Turn off power and you can start the truck, if the install screen is still up hit the X to close. Mat said in eariler posts P493...#9854.

Edit: OR Post above....he can type faster than me.