What Have You Done To Your 3rd Gen Today?

Installed an OEM pop’n lock tailgate kit.
Really love how my Tacoma was prewired for that and the bed lights!

 

$302 ECOTRIC Rear Bumper W/Step Plate, 2x 18W LED Lights Compatible with 2016-2023 Toyota Tacoma Full Width Pickup Trucks

https://www.amazon.com/dp/B08R19T9P...abc_KN0EZ54QZYB06A3BMG82?_encoding=UTF8&psc=1
If it's out of stock there were two or three clones for around 450.

 

I got bored today and removed the ugly frame extensions by the skid and capped them off - https://squareonecreations.com/collections/accessories/products/bumper-end-plates



Then I installed a set of REKGEN flaps

 

I see you managed to fit your bumper plastic over your steel bumper end tangs on your Hiline bumper and looks much better. For the life of me I couldn’t make mine fit and had to install it as suggested. Pulled and tweaked my other plastics too much. How’d you make it work?

 

I tried like hell to put the lower façade behind the tabs. It just would not fit.

 

Got a pic?

 

Did you install the Hiline first or after the plastic?
I could see if you installed the steel first how you would have had a struggle

 

Replaced the lower bearings on my Fox coilovers, shoulda did it when I had my buddy rebuild them but skimped on it. Nice and silent now

 

I added dual cyclone under the hood flood lights today. Thanks to @Skydvrr for the idea
Also, thanks so much for the Trans cooler mate.

 

I pulled the lower façade, cut it and put on the cement colored edging. Then I mounted the highline bumper and put the façade back on.

 

well this was last week but I installed ditch lights they helped out alot during our snow storm. In combination with led headlights and led fog lights and hidden light bar dude i love it i would like to get a rack and have a light bar up top but someday maybe

 

love that winch bumber low profile like

 

that looks like our beach sand here in the PNW in washington

 

Padre Island, TX

 

Club is getting bigger!

 

I hope ya'll don't mind me asking this question here. But do you know if wheels off a 2018 Colorado (that's all they provided) would fit a 3rd gen? From what I'm seeing online, I *think* the bolt pattern is different?

 

Do you have a link for the OEM pop'n lock that you ordered? And how did you know it was prewired for it?

I have the 2021 TRDOR and it was prewired for bed lights but im not sure about the tailgate lock.

 

Sweet man!!! I'm interested to see how it affects temps

 

You may find the answer here.