Fitting 35’s with minimal trimming NOW ADDING LONG TRAVEL AND 934 CV’s

I got gad for less than 1/2 per gal. Our mid grade and Supreme jump up a lot more than that though it's like 20 or 30 cents up ea. from the last.

Be safe have fun and post lots of pics of that truck in action.

 

Gonna have to call the shop for that. There’s a lot that is available but not up on the site yet

 

A lot just got added too. It's come a long way in a short period of time.

 

On the deaver website the h70 spring for the kit are 5 inch lift. Is this correct? That truck doesn’t look 5 inchs? I know he made some new mounts and a long shackle does that lower the truck back down some?

 

The JD spring under kit is mounted on the outside of the frame. Tucked up higher than the low hanging shackle mount with their design. More than likely accounts for that.

 

Had @Yotamac from TacomaPros burn the lca kit on today. He also burned on the exterior gussets included with slide rack, and the full plates for the 934 cv notches. I’m going to pull the rack next so I can cut the notches out for the slide rack. The next go around we’re going to burn on the full plates for the slide rack notches, the slide rack tabs, upper arm double sheer gussets, and bypass mounts.

This was a huge part of the puzzle that got done today I’m super excited to get more going on soon.

 

Did you test fit the 934s?

 

Yes, I did so before the plates and when they were tacked on.

 

Sweet yeah, it's a tight squeeze!

 

What wheel spacers do you have to run? Glass or fenders chopped?

 

I don’t know the specifics, I don’t have their spring under kit. That’s after I finish the front. I currently run archive garage sua kit. I have to use spacers to help stay off the shocks.

I have glass personally, though their spring under kit should fit with trimmed oem fenders. I’m not sure if they fit with untrimmed.

 

For sure gotta chop about 2 inches off the OEM fenders. Not sure about spacers but with the angle he leans the shocks forward you may be able to not have to run them.

 

yea, even the filler neck gets repositioned. Fender trimming with SUA when fully stuffed. I'll get some pics in the morning. The flex pics Harry posted are with 33's.

 

@Evenflow looking good with the +4

 

Ohh black Kings! Solid!!

 

That upside down sticker is going to get to me...

 

I ordered new ones but Kings is back ordered for 3 years

 

It's funny because it's true.

 

They sent me extras with my kings

So what you're saying is ill have my rear before the front

 

Heatgun loosen the adhesive enough to rotate it?