Driver side cubby hole

I desperately need one of these
For now the tekonsha is sitting in the stock cubby

 

This.

 

Thanks! Ordered.

 

Garage door opener.

 

Anyone know the Toyota PN for the entire cubby plate with or without the actual snap-in box?

 

5544604071C0

Cubby Hole Link

 

My Colorado had one the size to hold a ID /credit card/toll ticket... but you pretty much could not see it from the driving position and I never used it.

My OR does not have a cubby or a sunglasses holder.

 

Awesome, Thanks!

 

Funny, an hour before your post I just researched it on how to remove it so I could install a Caliraised switch panel.
Good luck with your project.

 

Mystery switch

 

lol, it's my anytime rear camera.

I had it on an actual rear camera small switch in the center console but had to move it to this location and had this switch laying around.

 

I'm sure I saw instruction on here somewhere on how to remove the Drivers Side Cubby hole to install the Tekonsha brake controler. Can anyone direct me to it? I'm afraid I'm going to break the plastic trying to get the Cubby out. Thanks

 

I was able to remove mine just by getting a thin plastic tool under the lip and prising it out. It seems like it will break but it didn’t. No screws or anything it just snaps in and out.

 

I got it out. Googled & found a how to video.

 

I have a coin holder in mine.

 

do you have the order information if we were wanting to get this same option from meso customs?

 

https://mesocustoms.com/collections...ducts/3rd-gen-tacoma-custom-made-switch-panel

My 2017 has the power rear window switch in that location. I know 2018 moved it to the lower center panel. Not sure about the 2016 model year though. So you would have to be sure to check that out prior to ordering one.

Custom orders are currently closed , but you can sign up for email notifications for when they open back up.

My layout is:

Top : F
Bottom: E,B,A,B

But again double check the rear sliding window for 2016 model year.

 

And since you'll be re-designing it (with apologies to @caribe makaira ) how about a coffee-cup holder?
And a warmer too?
Place to put my cigar?
Maybe a loop to tie up my horse when I head into the saloon or mount my folded dipole antenna?

 

I cut a bit of ABS from a broken, plastic toolbox and made a switch plate to fit where the cover was. These low-amp switches go to the relays for my lights.