What Have You Done To Your 3rd Gen Today?

Pics?

 

Compared to removing the old ones and the adhesive how difficult was installing the new ones, including dealing with the new double sided tape?

 

Same with me

 

Prepping the surface was the hardest part. Soap and water to get rid of any dirt, goo gone to get rid of any old adhesive residue, IPA to get rid of any contaminants for the new double sided tape. Start on one end, pull the backing on the tape just past the first clip and pop it in, pull the backing further and pop the next clip in, repeat until complete. Install screws and you're good.

It's a super simple install to put new ones in. I got lucky and got a brand new set with clips and double sided tape installed on them already.

 

$13 Alla Lighting 912 921 LED Bulbs for Back-up Reverse Lights, 6000K Xenon White CAN-BUS 4014 30-SMD T10 T15 906 W16W 921K 922, 360° Light Backup, Cargo Lights Replacement, Extremely Super Bright

https://www.amazon.com/Alla-Lightin...B072FHNZKW&qid=1614305490&s=automotive&sr=1-1

 

Where did you buy these? Do you have part numbers?

 

Is there an alternate way you can route that hose? That bend looks like it's going to put a bit of stress on the hose/fittings.

 

No paint warranty. Unless you had bought paint protection. I'm sending everything to Corporate.

 

Thanks man. Whether it be because mine get damaged or I find a deal on some I'd like to replace mine with the black textured ones as well. Looks great on your truck.

 

Offerup from a guy who deals in parts. He's in San Diego and ships.

They were new but had some minor surface scratches so I paid $250 for a full set of OEM.

 

Diggin’ the Popeye decal too!

 

So I was taking an online course for work today and when you answer a question correctly there will be a congratulatory message at the bottom of the screen.
I’m starting to wonder if either Toyota or my Tacoma is stalking me.
The course I was taking was related to cash automation equipment and has nothing to do with cars or trucks by the way.

 

Is there a way to measure this or just personal opinion?

 

Got the basics of my light bar wiring done, the relays I put inside my factory aux relay/fuse box. The only thing that was in the box is that small blue relay and the single fuse. I ordered the pins to put in the 2 more fuses so I can remove the fuses I have hiding under the box.

I still need to do a little bit of work on the wiring, mainly I need to setup a real power wire going to it, and route that power wire into the main fuse box instead of the top stud of the battery.

Ignore the red and black wires that are near the blue and white, they are not hooked up to anything, the red wire needs to be removed from the loom, the black wire will be plugged into the other trigger wire(other red wire on the right side) then routed to my "press to turn something on" switch.

 

Let me know how the install goes.

 

Damn. I need some. Went to parallel park the other day... started hyper flashing. I wonder what it looks like back there

 

Shiny again! Refreshed the CarPro quartz sealant that I had applied a year ago with CarPro Reload.

 

Just trial and error.

 

Looks awesome!