Blackhorn Wheel correct fit?

I'm looking at new Canadian wheel company "Blackhorn wheels" they have a BH02 wheel in

17x9.0 +12 6x139.7 106.1 question will this size fit my 2005 Tacoma 6 lug not lifted?

If so what is largest Faulken wildpeaks I can run with on those wheels?

Thank you very much

Dan

 

I think most here run a 0 offset with a 9" wide wheel to get a little poke out. I think it will fit, however if you ran larger then a 33" tire or wider then a 12" tire i believe the tire will rub the upper control arm.

Im definetly no wheel fitment expert though. Hopefully that helps!

 

Largest tire size on stock suspension. 265/70/17 but I would go with a 17x8 instead of 17x9 wheel for a tighter tire bead. +12 offset is close to factory.

 

That’s a 5.5” backspace. That’s pretty much the limit for backspace. If you’re planning staying stock. Go 17x8 0 offset. 265/70/17 like Watta mentioned. It’s a good happy medium.

 

So in your opinion would I be safe ordering these "17x9.0 +12 6x139.7 106.1" even though 9" wide wheels as this is only size they have for my 2005 tacoma no lift? and the 70 instead of 65 tires or stay with 65 due to 19 wide?
Thanks i appreciate your knowledge...

Dan

 

265/70/17 is the same width (approx 10.5" wide) as a 265/65/17. 265 is the width value but I would go with the 70 ratio tire which is 1" taller than a 65 ratio tire. 265/65/17 will be a tad small IMO.. If you don't plan on offroading in low psi situations, then the setup would be fine with a 9" wide wheel. If you do experience minor rubbing with a 9" wide wheel, it can be easily corrected with a small spacer. Not my preference for offset or width but if you are really set on this particular wheel style, then you can make it work.

 

Thank you very much !! going with the Blackhorn BH02"s