1st Gen Lunchtable Thread - General Discussion

Set something up and tell me where I can drop it off and I can work something out. I could take it to Miguel's shop.

 

I followed the dirty pool write up here on the forum. The tool wasn't that bad to make, just a bushing that I ground the sides down on. Getting the Teflon seals on without tearing them or distorting them too badly was the real challenge

 

I'll talk to the guy at lunch and let you know. Thanks

 

Started the green truck this morning after sitting for a week and got a new noise. Sounds like a belt pully. Can any one confirm?
https://photos.app.goo.gl/HyXoaz8EWhKp3dzg7

 

Yeah that's how my idler pulley bearing sounded when it started to go. Could feel it wiggle by hand when you grabbed it with the engine off. Chirped pretty loud while running

 

When they give you that tilt head look

 

Taco driver must be a chunky monkey

 

There was a drop-down menu I hadn't seen earlier

 

Thanks, Ill check it after work. If that's it ill swap it out this weekend.

 

Wasn’t Tyler’s making noise in Moab?

 

I think that was more of a squeal not a chirp, but yeah with all that Moab dust it was bound to happen to someone. I think @Kwikvette had a squeal too at some point

 

Thanks now the deliverance banjo song popped in my head.

 

Yeah, I remember telling Tyler it was a dirty belt.

Then when we left the parking lot, I had the same ordeal. Only happened once at startup when I had my AC on.

Shut it down, turned off AC, turned it back on and never came back.

 

Y’all need to get dusty more

 

What if there's only snow here

 

It’s California, I know that’s not true

 

I don't think I ever changed the pully 320,000 miles it may be time

 

I get nothing but dust from may to October!