Ontario BS Thread

Love that color

 

Should look bitchin' with the white!

 

Wow super cool rims!

Make sure you tell the guys who mount them up to go easy and not scratch them up.

Perhaps they can put the balancing weights on the inside?

 

TEC Winter Exploration recoveries were much better than this.....Hard to believe this is real!

https://www.tacomaworld.com/threads/cleghorn-tacoma-recovery-ouch.710456/#post-25255498

 

Oh I have a friend of mine who looks after my tire needs. So no worries for scratches as I will be the supervisor.
Yes all wheel weights are sticky and go on the inside...where ya been for the last few years? Lol
I won't get them mounted for another month anyway gonna run my stockers and Duratracs till at least till the end of the month.

 

Shows you how much I know about tire weights!!

 

You and I are around the same age where we remember the hammer on lead weights.
Really your less likely to throw one of the old ones than the new stickies.
I had my buddy hammer the old lead ones on the inside of the rallies on the 65.

 

Keep the center cap or go with a bronze/red TRD cap?

 

TRD cap

Or maybe paint the bronze cap black? You could always plasti dip them to see and peel it off if you don’t like it?

Are your badges chrome or black?

Black badges on a white vehicle look way better than chrome IMO

I always paint my centre caps different colour because I’m goofy

 

I don't think I can paint the caps black..it would just make it look like there wasn't one there at all. If I can't find a TRD one I can paint the Motegi logo red...just an idea.
I'm goofy too..lol

Yes my logos are black on the white truck..waaaay better.

 

Can't remember the last time I heard someone say bitchin'...

I like it as is. Keep it simple and classic.

 

Looks like Mo wheels. Nice ones too

 

What's the hole diameter? Looks like it steps down from the 106mm hub bore. Maybe the F-Sport center cap will fit?

 

LOL,
I looked at this picture, got nothing, looked at the measurements, saw the 255 r16, and though... "so small..." , only later i paid attention to the "/85", and then i thought, "oh, they're Pizza Cutters". Doh....

 

Ok I can use cool..decent...wicked....sweet..tits....fantastic
I tend to agree about the center caps...

 

106 mm

 

What's the hole diameter for the center cap? That clearly isn't 106mm.

 

fixed it for ya.

 

315/70-17 255/85-16 Difference
Diameter inches (mm) 34.36 (872.8) 33.07 (839.9) -1.3 (-32.9) -3.8%

basically what I have.
Yes welcome to the club

 

ghay-rb version 2, is almost there. Its mounted just need to finish it up with electricity and plumbing. Its an old Mikita air compressor tank, the solenoid, relay and switch I had laying around for years, all mounted to a piece plywood. Hopfully by next week I can test it out.