What have you done to your Tacoma today? 1st Gen Edition

vinegar works well too.

 

I tried that, but mine wouldn’t come off with vinegar. May have been baked on too hard.

 

anybody know of any good seat rails for aftermarket seats? looking to finally pull the trigger. probably going with some NRG seats

 

Looking to upgrade my harness as well

 

Have the file for this?

 

I installed my switch panel,

just the panel though, not the fuse box or anything, that’s gonna have to wait till next week.

 

looks really good, gj.

 

https://www.tinkercad.com/things/hUWeecWWND0

 

Have you looked at Corbeau or Mastercraft?
They both make specific brackets for our trucks.
Don't know about compatibility with NRG though

 

Looks clean.
I need to get my Cobra installed again.

 

Thanks for the link. They look fitting.
My rear spots need replaced, and this will fit the need perfectly.
I might buy 2 sets, and add the ditch lights to the same circuit.

 

The kids seem to work better with a big plate of spaghetti in front of them. LOL

 

No. Trying to save the benji's. Lol

 

Im going to hit up tognottis. They have tons of shit. But mostly for hotrods

 

I think most people just cut and weld rails they have, I can see the appeal in not doing that though.

 

Demonstrated my recovery skills to my unit.

 

First Post. Been reading on here a while. Had toyotas ranging from 1980 to 2001 (current black Limited double cab which is my hunting truck). Today i installed OME 2883 springs w/ Bilsteins, new ball jts upper and lower, new front axles, tie rod ends, brake pads and rotors, and rear bilsteins. Im putting the ARB bumper on sometime soon. I've had the truck a few yrs. Figured since it was 20 years old, it needed some attention. Great site. read lots of useful info.

 

Is the rust issue on 1st gens just as bad on 4runners. 05 model. Almost picked one up tonight but glad i looked under.

 

Yeah, it's still a boxed frame stuff inside can rot it out