What Have You Done To Your 3rd Gen Today?

Removed air damper, factory brace supports and factory skid plates



Installed rock rails and a full skid plate.


Paid homage/tribute to friends who survived a rollover back in January. They survived. The 2010 Taco is a write-off.

 

Glad to hear they are ok. What wheels are those? They don't look like any of the ones I have seen on the current model years.

 

Threw some spot pods on behind the grill until my bumper comes in

 

No photos, but I began the summer conversion a couple of days ago by tossing the LEDs back into the truck. It's like I can see again!

 

Engine no trans yes. Going with a big bore kit with the 1600 I have now. Car will be a mild outlaw.

 

Thank you! That’s the shot I needed. That’s a cute pup by the way.

 

I installed Rokblokz mudflaps, 15-20 minutes.

 

Will the switch still work to turn the ECT PWR off, or is it just always on?

 

Your Tacoma looks great. I think they look so clean without all the stickers and emblems on the truck.

 

The wheels on both of those trucks appear to be Tacoma TRD Sport wheels that were stock from 2016-2019. Basically the predecessor to what are on your truck @DJFriar.

(Pic courtesy of ebay)

 

how much are the mini aussies running where your at. Here because of covid they are $4800

 

Just the speakers....

any better head units? That have a clean install and of course have the bu cam...

 

Those are 16-19 trd sport wheels

 

This morning I opened up my storage case on my roof platform after it rained last night and all the water on top of the box dumped on the roof but since the platform is out past the rain gutters I got a front seat full of water because I had the door open so I wouldn't touch the wet truck while standing on the nerf bar.
Now I get a wet butt driving to work.

 

Picked up my hitch skid and bed stiffeners from the Line X shop. They did a fantastic job. Note to everyone, don't let your 7 year old daughter carry the heavy steel part, even if she wants to. One bruised forehead later and I've already got tears on my skid plate.

Oh, and while I was at the shop to pick up my parts, I got the notification that my bumper has shipped so it looks like I'll be back at Line X next week. Still waiting on the roof rack from UpTop, the remaining parts of my lift from Dobinsons, and lights from Baja Designs. Going to be a busy month. I hope to have everything installed and ready to go for a trip in April.

 

I punched out the factory pins that hold in the rear seat cushions and replaced with the quick-release type. I can now remove on reinstall the seats in about 30 seconds without tools.
I also constructed a cargo/dog platform. It can fold up on itself for ease of installation and so I can access storage underneath. I’ll make a second piece to the platform in a few days so I’ll have the option of leaving 1, 2, or all 3 seats up or down.

 

Awesome!

 

Day 1 -- I whipped out the old hair dryer and fishing line.

I couldn't agree more!

 

Factor in gravity and inertia too...lol--- but yeah it's better than the slippery hard surface that comes stock.

 

I put a set on my F250. They worked great out of the box but the output went down significantly not long after (needed new bulbs) and the "coating" on the lights started peeling within a year. I was not impressed.