What have you done to your Tacoma today? 1st Gen Edition

Wish I new of this site earlier dam good prices.

I’ll have to try this looks promising, the basic ep35 did not solve the issue.

 

yep. Well, mostly there. Final steps.

 

my tacoma will run before you're done

 

Done with what one?

 

My green one boi!

 

I was talking about him

 

I'll take that bet. what are we wagering? haha

 

Disappointment

 

Teenager been has bad taste.

 

Most teenagers do

 

I've been wanting to get some of these things for cruddy cat bolts.

 

The Any tips on how to level my bed out? The right rear corner is jacked up a bit

 

I think the easy way would be to space the lowest corner side of the bed mount.

 

real late on replying to this but yeah, i'm in Bozeman. dropped the truck off to get the timing belt done today, think i'm going to wait on the rack a bit longer. I have a place to work here in Bozeman that can rent shop time for $5 an hour but they generally only like to rent time for stuff like oil changes and tire rotations, quick stuff. we'll see. If i do the rack anytime soon it'll be over this summer and i'll do it back in WA where all my tools are.

 

tape strings *tightly* across the bed from corner to corner in an X. Then install spacer washers in the left rear bed mount until the strings tough each other in the center.

 

Is your frame bent or bed mount collapsed?

 

The frame is all straight, I'll have to check bed mount. there's a spot on the right side between the frame and bed where the bed is just floating. On the left side that part is resting against the frame

 

Note:
I have front LED turn signals and rear Incandescent turn signals.
Planning on replacing the entire rear indicator turn/stop/reverse housing to LED as the right side has seen better days.

 

Ultra gauge, for more info I don’t understand

 

Make sure you set up a bunch of annoying alarms.