What have you done to your Tacoma today? 1st Gen Edition

881’s sorry

 

Correction. 881’s

 

You're likely going to tear the boots pretty quickly with the fins touching. Diff drop may help just enough.

 

Hope your good at changing em.

 

My cv’s only spin when i tell them to

 

I'm going to look real dumb for a second, even if it's a regular occurrence. I plead ADD hubs.

Isn't "cv's only spin when I tell them to" the way manual hubs work?

 

It is with manual hubs

 

I took mine for some Swaybar Delete / Pre-OME Lift playtime.

 

I was about to say I'd go around with an angle grinder, sketch it out and cut them like this guy did. If u smacked once u will again unless u address it. Looks good so far tho!

 

Yes, that is how manual hubs work.

You do not look dumb for asking that question.

 

Either way..thats too much lift. Those poor CVs and ball joints. Ouch.

 

taco2021,

which shell is that on back? been looking for one for mine

 

It's a Leer 100XQ

 

The good stuff

 

It's always good when the thrust bearing shits itself out in pieces

 

Be sure to rotate your crankshaft by hand until the valves are closed on that port before cleaning it.

 

I added power seats to my tuck this past weekend. Where would it be easiest to get power for the seats? I just need power and ground and both seats would function. Is there a wire or two in the cab I can tap into that can carry the load?

 

Speaking of seats, what would bolt into a 95.5 single cab 4x4? I'd like to replace the worn buckets someday. Somebody said something about some acura once but didn't know model or year.

 

Only bolt in seats are other Taco seats.

 

looks good, primary colors