Colorado B.S. Thread

Damn. I was hoping you could do my taxes and 5speed manual swap at the same time in my new garage.

 

you're kidding. I'll check that with the radiator. I was unaware that it had a particular clocking.. whoopsies.

I will be doing this.

System was certainly burped

I bought a block of CL 2 years ago, and tore it down nut and bolt, had surfaces planed and replaced everything except piston heads and rods. I've put more than a few motors together, I'm positive I assembled it properly, though reading this sparks a tad of doubt lol.

Thank you guys! I'll report back

 

This, and throw it in a pot of boiling water to make sure your "new" thermostat isn't defective if you haven't already

 

Another project for @Wulf and @literallynothing :
2004 F-350 XLT SUPER DOODY! Only $2250!!!

 

quote for visibility

 

if I had the time/energy to part that out

 

I'll be heading to the springs on sunday but was gonna be taking the wife sentra..

 

wrap it in a bunch of trash bags and throw it in the back seat

 

i'll respond to the chap in his thread

 

More of a shot show than a project

 

Bird or buck?

 

I saw a wrecked runner for about the same price

 

c u m

 

It's officially official
Casa Bonita is Re-Opening!!!
https://1067thebull.iheart.com/feat...vXiYhUk-qi58qouVrprGXSWIeYu6gNsCNlJwJtJl4wISY

 

I wonder if they every paid their employees back pay.

 

Target

 

it's a sink or swim business

 

Wondering if anyone has experienced this and could provide some insight. Went to take the kids sledding Monday and I got a warning twice within a few minutes of each other that my engine oil was low. Each warning only stayed on for a few seconds. Oil level looked fine. Since then I’ve driven the truck a few times, maybe 3 or 4 times for a about 30 miles and the warning light hasn’t come on again.

The only thing I can think of is that I drove the truck through some pretty deep snow Sunday and Monday morning and maybe snow built up above the skid plate and triggered a sensor. I checked the oil pan bolt (fumoto valve) and filter and both show no signs of leaking. What do you all think could of happened? Should I be concerned? Thanks in advance.