TRD/ Magnuson 4.0 Supercharger Tips, Tricks, and Mods

is it the arp 424-1301 (8mmx1.25 1.750 long)?

 

I'll call Monday when they are open!

 

I just checked my Summit order, it is 6/18!!!

 

434

 

That! lol

 

Whew......you had me thinking I ordered the wrong set

 

Pardon the fat finger

 

Because them Texans are elusive ones. Lol.

 

Tuesday I'm have a machinist at work grind down the my Roush tensioner. I'll take some pics! We just need to clean up enough so the double bearing has enough clearance to spin with without any possibility of touching the tensioner correct? I'll the pic from pg 1 as a reference!

 

That's correct.

 

i did the same

 

Got a question for you 6spd guys : for the drivers side rear “b” bracket , how did you mount the hydraulic clutch line bracket to it ? I’m running in to clearance problems with it while mounting the blower.

 

I’ll snap a pic of that area in a few for ya

 

This is looking down from top between case and inlet. Second pic is back corner where inlet goes into the case. Hope this helps.


Mine is behind that bracket b. The smaller nut you see in first pic "the shiny one lol" is the stud for the clutch line bracket.

 

Happy birthday duder.

 

Ok , I ended up drilling a new hole in the bracket about 25mm below the top bolt, and was able to push it down just enough to get a socket on the top mounting bolt thanks guys!

 

Semi urgent question!

Do any one of you boys live close to Arkansas? PM me if you do.

 

Thank you

 

Could it be you have the wrong bracket back there? I believe both of my brackets had a b on them but the non mounting holes were different.

 

Called this A.M. shipping out today!