What Have You Done To Your 3rd Gen Today?

Nope! It clears the big bolt just fine. I was worried about it as well.

 

What’s that system you’ve hooked up to the scepter?

 

It is a 12v switched faucet with an added submersible pump.

Tutorial here https://www.youtube.com/watch?v=wNHp5F-d2c4&list=WL&index=6

Running water from a Scepter can, just plug it in to any spare 12v lead on your rig.

 

After 6 months of ownership I finally ordered the bed mat, with as much press as it gets on this site I'm sure my Hp will increase and gas consumption will decrease. Hopefully the install goes smooth...lol.

 

I removed the black vinyl from between the windows. Washed, clayed, paint correction & ceramic coating. I hadn’t really thought much about the vinyl until I saw a thread about it on this forum. Then I started paying attention to Tacoma’s and other trucks and decided it had to go. Love the results.

 

I didn't wire it up, so I couldn't tell you? All I did was wire in the solar panel to the RedArc the next weekend.

 

L

Now thats slick!

 

Smooth diamondback hd came on the freight truck today

 

Welcome, paint looks awesome! Can you elaborate on what detail/ceramic products you used? I'm always testing new detail products and like to hear what others prefer.

 

Been using “The Last Coat” products. Got a starter kit that had a clay mitt, Black Ice (ceramic), The last coat top coating, The last coat soap and a Detailer called Amp. Been very pleased with the results. I’ve done two Tacoma’s and two Jeep’s so far and have plenty of product left with the exception of the soap because you use it as the lubricant for the clay mitt.
The paint looked like it had been through a brush type car wash every day of its life. Couldn’t wait for a warm weekend to get it rubbed out and protected.

 

I did this to my 2020 TRD Sport and am really happy with it.

https://usrallystripesshop.com/prod...-tacoma-tundra-4runner?variant=29207626317923

 

Ahem..

(I know, maintenance reminder)




This was coming down from Crater Lake

 

Is it not just a bit over the top to bolt 1/2 inch plus steel plate to members that couldn't be much over .080" ?

I'm thinking a "structural tie bar" that attaches to the "bumper arms" might be a good fab project.

 

At warp speed?! Did you put 25k on a ‘21 taco? I though I was bad with 16k on my ‘20.

 

Looks great man! I did the same. What tint are you running?

 

Your truck will never be the same again

 

Love Crater Lake, its gorgeous. Have yet to take my truck out there though since I live in Illinois

 

Installed these mictuning bed rail lights. https://www.amazon.com/gp/product/B01N0VYQCU/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8

The quality of the components ended up being a little lower than I expected, but it all works for now. Hopefully it stays that way. At any rate, it was cheap and they are bright!

 

I've got 10,100 on my 17.

 

I’m just shy of 26k on a 2020