What Have You Done To Your 3rd Gen Today?

I love the OEM TRD skid plate!, mine supposed to arrive in Alberta tomorrow...left Toronto last night...all the way from Texas!...just to save couple hundred dollars!

 

Do you have a link for the decal?

 

Just installed emblem overlays ordered from Taco Garage in San Diego. Simple, easy and looks good. Fit perfect though you need to be careful peeling off the double sided tape otherwise it rips in a tight corner and it’s a pain to get off again. That’s user error and not on the part of the vendor. The A doesn’t have a cutout like it shows on the website but it does in the O. I’ve seen others where it’s one solid piece so I liked that little detail with this set.

 

Nice, might consider this for fun. My Truck is cement and would look sick blacked out.

 

You will not be disappointed ! its a very well build skid plate, Makes the factory installed looks like a piece napkin !!!

 

I don’t know what percent it was, but the guy would not write a receipt for it. Haha

 

Ahhh I see.. did you just have him match the tint on the back windows then? I've never gotten tint before so I'm not too sure how to go about it or if I even want to bother but I'm assuming I just take it in and ask for it to be matched.

 

yes these are pretty much pNp. I would of went w/ bed light strips of my truck wasn’t already prewired.

 

All true. But I think the OP was just commenting on the fact that there is less read to begin with. And it does make for a lighter tire which will improve the efficiency rating of the vehicle.

 

Vicky, Here you go.

https://www.etsy.com/listing/958002...s-stickers?ref=shop_home_active_1&frs=1&crt=1

 

Yes you could do that. And that would be less expensive to just tint the front two windows. I had the back tinted darker and then the front matched. Some states don’t allow you to tint the front door windows. When I lived in Illinois can’t tell you how many times I had to peel the tint off or pay a fine.

 

Ty! I’ll take a look and compare these

 

Yeah, go for it! I think the set was a little under $30. Much cheaper than OEM from Toyota, but that does come with the whole set including the letters. FYI this set was just both sides and the V6 emblem. It does not have the 4x4 overlay, but that wasn't needed on my OR.

 

Living in Illinois right now
Maybe I should skip it ahaha

 

How was the install? Is it just bolt on? Thinking of grabbing one myself.

 

I never thought to look under my bed mat. Now I'm curious...

 

Where did you get yours and for what price? Most listings seem to be around $350 to $400.

 

2021 taillights and Diamondback HD cover.
5 mins for the taillights
1hr ish for the cover.

 

Just a suggestion. This is how I installed mine. The ramps provide enough space to lay the skid plate on your belly and slide under the truck with it. Loosely fasten the 2x bolts at the rear, then 2x in the front and then 2x in the middle. Tighten everything up after that.