What Have You Done To Your 2nd Gen Tacoma Today?

Shake the bottle, set the parts on cardboard or something to protect the floor, spray the shit out of them, wait about 15 minutes, scrub with a rag. 90% of the chrome came off without scrubbing on most of the parts. The Morimoto shrouds must have had a thicker layer of chrome, they required more time and a little more scrubbing.

 

The old sniff test. I just changed my rear diff fluid and definitely did not pass the test.

 

Retrofit shit

 

I was trying to remove the chrome from my grill emblem. Maybe I just need to let it sit longer. Thanks.

 

Made a small platform for the rear drivers side. Would have liked to do the whole back seat but I have an 11 year old niece that would be mad if she couldn't ride in Uncle Ed's truck. Used a piece of 3/4" mdf that I had laying around, plus I already had the d-rings and the short piece of 1 1/2" steel that I used. Attached it using the factory hinges so it still tilts forward and I can access the factory storage area if needed. After taking these photos I ran the router around it real quick to ease the edges. Going to probably just paint it tomorrow.

 

Got aligned this morning. Driving good! Changed front wheel bearing/hubs from 05Taco4x4's press service. Got lawn and garden on my parking brake line that was rubbing my icon rxt hardware.

 

Did you not drill out the bolt hole on the OE bracket that holds the brake line? I took a slightly larger drill bit to the hole and it worked just fine.

 

Yeah maybe try and let it soak for half hour or so. It doesn't seem to damage the plastic at all, give it a little more time to work. I'd try heating the emblem in the oven next time. The bottle says it cleans ovens best if you preheat to 200 degrees. I'm assuming this logic will apply to stripping chrome as well.

 

I thought about it but I'm just gonna cut those brackets off with a grinder. I think..

 

Kicked off "Spring Cleaning" with my Bestop Supertop.

 

Finally finished the radio and blackout on the dash

 

Interesting approach. I used wire loom but that looks cooler lol. I believe that bolt should be the other way so that the bolt itself is less susceptible to puncture into the gas tank.

Edit: Then again, should something catch on fire, you’re partially ready with your water hose lol! Sorry sorry

 

I

couldn’t get mine to lay flush...I have a few thread showing, should I keep cranking on it?

 

How you get the black hazard and did you rewire the ac controls from a newer gen? Thanks

 

i found the black hazard switch at a junk yard. got it shipped. $60... and Yes i did rewire and move the pins for the AC controls which i also sourced from the junk yard.

 

what kit is that

 

March Maintenance Madness continues. Flushed radiator and refilled with the pink stuff. Also drain and fill my AT. Had both done at my local dealer cause I'm old and have a sketchy back. Next up is a brake job, probably in June or July.

 

OOOO AWESOME IDEA! Thanks for the sharing brother

 

American international TOYK973

 

I actually like the kc covers more than I thought I would