What have you done to your Tacoma today? 1st Gen Edition

Also, what website?

 

https://platinumoutfitters.shootproof.com/

 

I wanna see some close ups of lions and bears with a 10mm fisheye

 

I can do that, buy me the lens

 

I put these in the rear, what a nice upgrade. They feel great.

 

With a 10 mm, that would put you about 18 in from heaven.

 

You doubt me

 

not if it's already dead...

 

This is how I get banned.

 

Hmmmm

 

Bought a Roachwerkz lighted ignition ring. Uses t taps for the a pillar wiring. Got it wired up and put a new bulb in the used ignition ring. It won’t light. The dome light works still so I know the a pillar wiring isn’t disrupted. Red wire goes to OEM black and black goes to OEM black with white stripe.
Any ideas?

 

Finally got my BAMF BPV extension bracket installed.

 

Hood made vibrating noise at low RPM. Didn’t know you could hand twist the rubber hood bumpers by hand to raise them and make the hood close more snug.

 

This thing?


That dude is obviously pulling em out of old 4Runners for probably a buck each. And he oughta know that these trucks dont like LED's on the domelight circuit.

 

Not sure if this helps.
https://www.tacomaworld.com/posts/22061127/

 

I actually got the ring and harness at a junkyard. I bought the wiring and harness from him. The install was completely my fault. There were two black wires- apparently one was for my Bluetooth mic. I tapped it by accident. The ring works great now. I do agree that the parts are used from 4runners as the black plastic ring was all scuffed from keys. But it works! I got the ring for free and the wiring was $35 and my time to install. I’m happy.

 

Installed these...........
UltraGauge MX v1.4
Auto Meter Voltmeter Model 7591
Spiker Engineering "2 1/16 gauge mount (ultragauge mount)
**Great Customer Service from Spiker Engineering.

 

It’s tomorrow

 

Thanks @Coupe

 

Got all lca bushings changed out also fixed the five mile an hour ABS glitch cleaned all for sensors good to go now!