What Have You Done To Your 2nd Gen Tacoma Today?

Haven’t started but likely start some today. Cleaned it all last week but haven’t had a chance yet.

 

I think I'll have to wait until I do the entire truck. I did the doors last year.

 

True neat to see how it changes. I wish I had done it before. I’ve done top/bottom/ rear and doors. Still need to add a layer of 150 to the doors though. I will prob toss some 300 over the 150 in some places on the roof since I have extra and there seems to be room.

 

I think my next step will to be to do the back wall.

 

Rago Fabrication (@ragofabrication) "blemish" bed stiffeners. I can't find a blemish, great product, very beefy!

 

You learn something new every day lol thank you sir. Although in my case it was simply the replacement of the tie rods.

 

That's odd. The only thing I felt felt with a worn tie rod was "loose" steering.
Now you made me want to check mine. I have a very slight pull when braking. The R/F caliper is new, the pull is slightly to the right.
A brake pull will pull to the opposite side of the bad caliper. So either my left caliper is bad or I also have a bad tie rod.

 

I think you misunderstood. It wasn't pulling it was simply somewhat of a loose feeling. So I replaced them. My toe was off after replacing them. And it rode fine but when I hit the brake hard one time it pulled to the right. I was driving like this for a day or two until my alignment appointment. Once aligned it was fine.

 

My mistake. I thought you said it pulled when braking and that's the only issue you felt.

 

Yeah it only pulled after I replaced the tie rod's not prior to. I tried to get them as close as possible but I guess I was still off a bit. Amazing what a small amount of change can do to driving characteristics.

 

Step 4. Complete
Installed the headliner, sun visors and dome lamp.
Installed a Bob’s mirrors (auto dimming, temp and compass) UltraGauge EM Plus.

 

Still planning on going back. But these were the numbers I got, aka they said everything is good to go?

 

If anyone is looking for a Sting Ray we happen to have one, in bare metal, left from the last batch we did. It's for a 12-15 Tacoma so if you are looking for one and would like it super fast give us a ring

Give us a call at 775-200-0544 between 9am-5pm Pacific (M-F) or email us at sales@relentlessfabrication.com to put your name on it

Relentless Fabrication
www.relentlessfabrication.com

 

I looked but didn't see a "Stingray" bumper for a 2.5 gen on your site.

 

Got the backup camera installed. A lot more time fishing wires, a lot less time fishing than planned.

 

There ya go man!! These are super hard to get, and not on the website anymore. They do extremely limited runs, so act fast if you want one. They may not produce these again.

 

Does it look like this?

 

Nice but the "TACOMA" has to go.

 

Went wheeling with @Dex__43 today since he's back out here visiting. Last time I saw his truck it was still a prerunner, and now after the 4x4 conversion and all other sort of mods, it is impressive.

fucked up my driveline and now I got a bad vibe

Sam's sexy converted 4x4

 

Installed Sherpa Equipment load bars and mounted ARB 4’ awning out the back. Will give me some good coverage for my camping setup. Think I’m finally “done” with my camper build and can put the wallet away.