Shop Time w/T.W. Friends

I seen this in a cartoon once...I think I can make it work

 

@tacotoe - Being that far into a vehicle scares me. I helped my dad replace the intake manifold gasket and water pump on my Blazer. Seeing valves and lifters and the pile of parts we had to put back on wasn't enjoyable for me but my dad had been wrenching long enough to not need a torque wrench and it was still spot on.

 

Now that I've got it torn apart, it looks like that carrier bearing was fine. On the truck it looked pretty loose compared to my 2017 with 20k miles, and it almost looked like it had spun inside the rubber. That wasn't the case though. I believe I was just seeing some grease grime around it. I'll have it together before long and if the aftermarket bearing goes bad, I'll let the dealer fix it with genuine Toyota parts.

 

Trying a little project today for the local snowmobile club

 

Is this thought of as City Puddles??

 

Hey 'Creed, what's up with the banner on your thread now? Who'd you piss off?

 

Bore and sleeve it? For spun bearing?

 

This was something else that made me question the condition of the center support. That little hole where the reused to be rubber. Well, almost back together now, and not even going to mess with u-joints they look great.

 

Exactly!

 

Well, a poorly maintained bearing

 

I've done that for a few electric motor end bells.

 

I don’t know but I like it! My little girl loves unicorns

 

Took the kids to some friends and they rode side by sides for the first time, I got to ride for the first time as well with my son. I still haven’t driven one.

 

New poll!!!

 

Something I made for a antenna. The bottom used to be a light press fit...like if you stuck your tongue out and concentrate real hard it would go...not after I dropped it 5 minutes ago

 

I vote leave it...at least for awhile. I think it's amazing what some people can do with photoshop. There's a guy at work who photoshopped me and the other machinist heads onto a couple of hillbilly looking dudes in suspenders. I think many would get very upset but I just had to laugh...

 

When I say hillbilly I'm talking squeal like a pig hillbilly

 

If y’all haven’t seen the original new picture up top here it is. @Cooldood photoshopped my truck and did a great job.


Here’s my truck and original photo.



Here is the one @StayinStock did.

 

Your talking about me then.

They wanted to film the movie a few miles away but the water was much to cold

 

That is neat!