1st Gen Lunchtable Thread - General Discussion

You quit

 

High pinion "4cyl diff" should still be good right?

 

@Abeyancer Fresh off work. Some more pics to give an idea. See idk about that wiring, I did fk up the window frame when was ratcheted down. will try to straighten it a bit but doesn't affect it.

Also screen was shit by my spare but other than that seems nice. U can see the front seal dangling

 

Interior lights I guess?

 

Yea that wiring is for an aux interior light probably, the black on the neg is the ground cause it's already got a ring terminal on it. Given it's age and condition I'd pull the windows before pressure washing. That way you can scrape the old foam off, it'll be way crispy. Watch out, there's gunna be probably 30 self tapper screws for each window frame, I recommend 2 people in case it wanna falls forward when you take the last screw out.

Amazon will have cheap foam seal tape for after you clean it and reinstall the windows

 

@Das it mang


Rereading your comment and zooming in on that last photo. You're completely missing a window and frame. Buy a sheet of plexiglass and get creative cause a replacement is like 450 bucks lol

 

Wiring prolly too flimsy for anything good right?

Shiiiet you'd say pull the windows too? I was just gonna spray into the seams where all the dirt gathered. Seals on side windows seem good, but that screen is clapped.

 

@Das it mang
This 3rd brake light mounts to top inside of Cap rear hatch frame.
Should be 2 holes there already.
The brake light shines through the glass.
https://www.ebay.com/itm/Truck-cap-...ird-brake-light-w-bracket-LB315-/322383779680

 

That makes sense now, I'll have to check. Think the wirings decent for anything else?

 

SOB. Shits boutta get a tire tube and snugged tight for now if I can. Idek how I'd cut plexiglass hahaha

 

I'd be lost with out u all

 

My original 3rd brake light also had a cargo light with switch. Can't find one like that now. You could run rope lights for that Rolling Ho House ambeance.

 

I cut plexi with a saw lol. Or you can score and snap

 

@Das it mang for long cuts i either use a table saw or skill saw and more technical cuts i use a jig saw. Then just use a sander to clean up the edge when i cut plexi glass

 

Rope lights would be dope and low energy if led. Wonder if I can splice for an aux plug too or if too much? Thank you

 

I've got a hack saw, that's the farthest my saws go. Wondering if I should check cl or something to see if someone can make me one cheep. Time will tell

 

If its thin enough you can score the plexi several times then snap parts off. But you can only really make straight cuts.

i dont most the custom plexiglass for work lol

 

Just get the AA battery Dildo