Ontario BS Thread

Just cut it so it dumps over the axle. Don’t want the exhaust on the axle ideally.

 

Red line is the best spot
Clears everything

 

Just looked under mine. Dont see a red line. Must be a 3rd gen thing lmfao. Seriously...thanks

 

No problem.
I should mention i don't keep my spare under the bed at all so if you are planning to keep it under there it might be best to cut it off half way through the next bend so it directs the exhaust away from the tire.
i also don't recommend leaving your spare under the bed when (or if) you plan on wheeling

Just something to consider if you plan on keeping your spare stowed under the bed

 

Just got the spare out of there on Saturday. New rack in the works to hold it

 

I plan to cut mine here, to keep the support of the last exhaust hanger:



All the hits off-road over the past few years had been on the tip - you can even see a dent where the pipe was pushed into the leaf shackle hanger. I can always cut the pipe back at the axle later, but there will be a lot of unsupported length.

Following a tip from Lite Brite, I keep my spare deflated to give it a bit more puncture resistance. I keep a Viair 85P pump in the truck at all times, and the twin-piston AliExpress monstrosity on wheeling trips.

 

but if you cut it where @tgelata says, you can slap on a dank-ass exhaust tip like them whistelin die-sel bois do it.


brb gotta bleach my mouth after saying that

 

i need conceptual images

i have a backrack with tie-downs but i don't trust it's strength to hold onto my spare tire right this moment.

 

Group buy teaser, hoping to have official up by the weekend.


*
*No affiliation with Henderson Brewery

 

I'll take a case

 

I'll take a case as well! Been to the brewery few times...good beer.

 

That's what I have in mind and I'm thinking about hanging the tire at the front by the back window

 

Easily distracted are we?


No judgement, it was a superb stout! No affiliation with the brewery.

 

I like the idea of using that hanger. I can always cut more later

 

What is the material? How much?

 

Hops, Barley yeast.....

If you can wait a few days I would appreciate it. I will have it all the details in a Canada wide GB post (Material, shipping, discounts, etc...). Will be sure to update here as well with a post to the GB thread.

 

Very nice!

 

Doesn't look fatter than any other can.

 

All you guys replacing your rear bumpers with aftermarket, what are you doing with your BSM sensors?